Damping characteristics of Al matrix composite foams reinforced by in-situ grown carbon nanotubes

被引：34
|
作者：
Yang, Kunming [1 ]
Yang, Xudong [2 ]
He, Chunnian [1 ,3 ]
Liu, Enzuo [1 ,3 ]
Shi, Chunsheng [1 ]
Ma, Liying [1 ]
Li, Qunying [1 ]
Li, Jiajun [1 ]
Zhao, Naiqin [1 ,3 ]
机构：
[1] Tianjin Univ, Sch Mat Sci & Engn, Tianjin Key Lab Composite & Funct Mat, Tianjin 300072, Peoples R China
[2] Civil Aviat Univ China, Sino European Inst Aviat Engn, Tianjin 300300, Peoples R China
[3] Tianjin Univ, Collaborat Innovat Ctr Chem Sci & Engn, Tianjin 300072, Peoples R China
来源：
MATERIALS LETTERS | 2017年 / 209卷
基金：
中国国家自然科学基金;
关键词：
Chemical vapor deposition; Carbon nanotubes; Interfaces; Porous materials; Damping properties; ALUMINUM FOAMS; FABRICATION;
D O I：
10.1016/j.matlet.2017.07.126
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The damping properties of Al matrix composite foams reinforced by in-situ grown carbon nanotubes (CNTs) have been investigated. The results show that the damping capacity of the CNT/Al composite foams is visibly enhanced with the CNT addition. The loss factors of the composite foams are found not only increase with the increment of CNT content but also increase with the porosity raising. For the 3.0 wt%-CNT/Al composite foams, the loss factor keeps the level of similar to 0.26 at 25-200 degrees C and further increases to 0.36 when the temperature is elevated to 390 degrees C, which is similar to 2.71 and 1.77 times higher than that of the pure Al foam, respectively. The damping improvement of CNT/Al composite foams is mainly due to the high inherent damping of CNTs and the formation of large numbers of well-bonded CNT-Al interfaces. (c) 2017 Published by Elsevier B.V.
引用
收藏
页码：68 / 70
页数：3
相关论文
共 50 条
  • [41] Enhancing the interface bonding in carbon nanotubes reinforced Al matrix composites by the in situ formation of TiAl3 and TiC
    Liu, X. Q.
    Li, C. J.
    Yi, J. H.
    Prashanth, K. G.
    Chawake, N.
    Tao, J. M.
    You, X.
    Liu, Y. C.
    Eckert, J.
    JOURNAL OF ALLOYS AND COMPOUNDS, 2018, 765 : 98 - 105
  • [42] Study on properties of carbon nanotubes/epoxy resin composite prepared by in-situ polymerization
    Zhang Yue
    Yu Mei-yan
    Lan Xi
    ADVANCED ENGINEERING MATERIALS III, PTS 1-3, 2013, 750-752 : 132 - 135
  • [43] In-situ formation of carbon nanotubes in an alumina-nanotube composite by spray pyrolysis
    Kamalakaran, R
    Lupo, F
    Grobert, N
    Lozano-Castello, D
    Jin-Phillipp, NY
    Rühle, M
    CARBON, 2003, 41 (14) : 2737 - 2741
  • [44] Fatigue life assessment of carbon nanotubes reinforced Al-Cu-Mg composite foams via statistics analysis and computer vision
    Wang, Siran
    Yin, Zhangcheng
    Rong, Xudong
    Song, Haipeng
    Yang, Xudong
    Zhao, Naiqin
    FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES, 2024, 47 (08) : 2905 - 2921
  • [45] Microstructure evolution and mechanical properties of carbon nanotubes reinforced Al matrix composites
    Liu, Xiaoqing
    Li, Caiju
    Eckert, Juergen
    Prashanth, Konda Gokuldoss
    Renk, Oliver
    Teng, Long
    Liu, Yichun
    Bao, Rui
    Tao, Jingmei
    Shen, Tao
    Yi, Jianhong
    MATERIALS CHARACTERIZATION, 2017, 133 : 122 - 132
  • [46] Effectively reinforced load transfer and fracture elongation by forming Al4C3 for in-situ synthesizing carbon nanotube reinforced Al matrix composites
    Liu, Xinghai
    Li, Jiajun
    Liu, Enzuo
    Li, Qunying
    He, Chunnian
    Shi, Chunsheng
    Zhao, Naiqin
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2018, 718 : 182 - 189
  • [47] Microstructure Characteristics of Fe-Matrix Composites Reinforced by In-Situ Carbide Particulates
    Huang, Xiaodong
    Song, Yanpei
    3RD ANNUAL INTERNATIONAL WORKSHOP ON MATERIALS SCIENCE AND ENGINEERING (IWMSE2017), 2017, 250
  • [48] Mechanical properties of in-situ growth carbon nanotubes reinforced porous ceramics by direct foaming
    Mazumder, Sangram
    Park, Jung Gyu
    Sarkar, Naboneeta
    Lee, Kee Sung
    Basnet, Bijay
    Kim, Ik Jin
    JOURNAL OF CERAMIC PROCESSING RESEARCH, 2016, 17 (12): : 1274 - 1278
  • [49] Vibration and damping analysis of functionally graded carbon nanotubes reinforced hybrid composite shell structures
    Thomas, Benedict
    Roy, Tarapada
    JOURNAL OF VIBRATION AND CONTROL, 2017, 23 (11) : 1711 - 1738
  • [50] Improving wear resistance of TiNi matrix composites reinforced by carbon nanotubes and in situ TiC
    Feng, X.
    Sui, J. H.
    Cai, W.
    Liu, A. L.
    SCRIPTA MATERIALIA, 2011, 64 (09) : 824 - 827
12345