INFLUENCE OF PLASTIC DEFORMATION DURING EXTRUSION PROCESS ON HEAT RESISTANCE ALLOYS Fe40Al

被引：1
作者：
Pasek, D. [1 ]
Cebulski, J. [1 ]
机构：
[1] Silesian Tech Univ, Dept Mat Engn & Met, 8 Krasinskiego Str, PL-40019 Katowice, Poland
来源：
ARCHIVES OF METALLURGY AND MATERIALS | 2017年 / 62卷 / 04期
关键词：
corrosion resistance; plastic deformation; alloys intermetallic phase matrix FeAl; Al2O3; extrusion; IRON ALUMINIDE; OXIDATION; MICROSTRUCTURE; FEAL;
D O I：
10.1515/amm-2017-0336
中图分类号：
TF [冶金工业];
学科分类号：
0806 ;
摘要：
The article presents the results of studies on the effects wrought on the corrosion resistance of the alloy matrix phase intermetallic FeAl. Researches were carried out on the Fe40Al5Cr0.2TiB alloy and involved the oxidation of the samples after the crystallization after plastic deformation made by extrusion. The tests were performed in an oven in air at 1100 degrees C for 100, 300 and 500 h. Determined to change the mass of the samples after corrosion research setting kinetics of corrosion processes, as well as an analysis of the microstructure of the alloy after the crystallization and after forming. The structure was examined using light microscopy and scanning electron microscopy and X-ray microanalysis with EDS chemical composition of the corrosion products. The test results revealed that plastic deformation during extrusion of intermetallic alloy led to structural changes, the effect of which was to improve the heat resistance at a temperature of 1100 degrees C.
引用
收藏
页码：2281 / 2286
页数：6
相关论文
共 50 条
[31]   Mossbauer study of plastic deformation in amorphous Fe40Ni40B20 and Fe78Si9B11C2 alloys [J].
Kane, SN ;
Gupta, A ;
Varga, LK .
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS, 2003, 254 :501-503
[32]   Influence of Severe Plastic Deformation and Aging on Low Cycle Fatigue Behavior of Al-Mg-Si Alloys [J].
Kim, Wonhoe ;
Kim, Kibeom ;
Kim, Kwonhoo .
MATERIALS, 2024, 17 (09)
[33]   3D FEM simulations for the homogeneity of plastic deformation in Al-Cu alloys during ECAP [J].
El Mahallawy, Nahed ;
Shehata, Farouk A. ;
Abd El Hameed, Mohamed ;
Abd El Aal, Mohamed Ibrahim ;
Kim, Hyoung Seop .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2010, 527 (06) :1404-1410
[34]   Transient negative strain hardening during severe plastic deformation of Al-30wt%Zn alloys [J].
Borodachenkova, M. ;
Gracio, J. ;
Barlat, F. ;
Picu, C. R. .
CURRENT STATE-OF-THE-ART ON MATERIAL FORMING: NUMERICAL AND EXPERIMENTAL APPROACHES AT DIFFERENT LENGTH-SCALES, PTS 1-3, 2013, 554-557 :3-11
[35]   Deformation behavior of commercial Mg-Al-Zn-Mn type alloys under a hydrostatic extrusion process at elevated temperatures [J].
Yoon, Duk-Jae ;
Lee, Sangmok ;
Lim, Seong-Joo ;
Kim, Eung-Zu .
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2010, 24 (01) :131-135
[36]   Deformation behavior of commercial Mg-Al-Zn-Mn type alloys under a hydrostatic extrusion process at elevated temperatures [J].
Duk-Jae Yoon ;
Sangmok Lee ;
Seong-Joo Lim ;
Eung-Zu Kim .
Journal of Mechanical Science and Technology, 2010, 24 :131-135
[37]   The Segregation Behavior of Alloying Elements in the Al-5Fe-Based Alloys During the Semisolid Deformation [J].
Bo, Liu .
JOM, 2015, 67 (12) :3030-3039
[38]   Structure and development of slip lines during plastic deformation of the intermetallic phases Fe3Al and CuZn [J].
Brinck, A ;
Engelke, C ;
Kopmann, W ;
Neuhauser, H .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1997, 240 :180-187
[39]   Influence of mechanical and heat treatment on structure evolution and functional properties of Fe-Al-Tb alloys [J].
Palacheva, V. V. ;
Mochugovskiy, A. G. ;
Chubov, D. G. ;
Koshmin, A. N. ;
Cheverikin, V. V. ;
Cifre, J. .
MATERIALS LETTERS, 2022, 310
[40]   Effect of Severe Plastic Deformation on Wear Resistance of Sintered Al-Sn Alloys under Dry Friction Against Steel [J].
Rusin, N. M. ;
Skorentsev, A. L. ;
Kolubaev, E. A. .
JOURNAL OF FRICTION AND WEAR, 2020, 41 (03) :259-266
12345