Experimental Study on Bi-Axial Mechanical Properties of Warp-knitted Meshes with and without Initial Notches

被引:10
|
作者
Shao, Huiqi [1 ,2 ]
Li, Jianna [1 ,2 ]
Chen, Nanliang [1 ,2 ]
Shao, Guangwei [2 ]
Jiang, Jinhua [1 ,2 ]
Yang, Youhong [3 ]
机构
[1] Donghua Univ, Minist Educ, Engn Res Ctr Tech Text, Shanghai 201620, Peoples R China
[2] Donghua Univ, Coll Text, Shanghai 201620, Peoples R China
[3] Guangdong Polytech, Foshan 528041, Peoples R China
关键词
warp-knitted mesh; mechanical properties; bi-axial stresses; isotropy; initial notches; PELVIC ORGAN PROLAPSE; BIOMECHANICAL PROPERTIES; TENSILE BEHAVIOR; TEAR RESISTANCE; COATED FABRICS; COMPOSITES; STRENGTH; REPAIR; HERNIA; CRACK;
D O I
10.3390/ma11101999
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Warp-knitted meshes have been widely used for structural reinforcement of rigid, semi-rigid, and flexible composite materials. In order to meet the performance requirements of different engineering applications, four typical warp-knitted meshes (rectangular, square, circular, and diamond) were designed and developed. The mechanical behaviors of these meshes under mono-axial and multi-axial tensile loads were compared. The influence of the initial notch length and orientation on the mechanical performance was also analyzed. The results showed that the biaxial tensile behavior of warp-knitted meshes tended to be more isotropic. The anisotropy level of the diamond warp-knitted mesh was the lowest ( = 0.099), while the rectangular one was the highest ( = 0.502). The notch on a significantly anisotropic mesh was propagated along the direction of larger modulus, while for a not remarkably anisotropic mesh, notch propagation was probably consistent with the initial notch orientation. The breaking strength of warp-knitted meshes with the same initial notch orientation decreased with the increase in notch length in both the wale and course directions. For warp-knitted meshes with the same initial notch length, the breaking strength in the wale direction was kept stable at different notch orientations, while that in the course direction decreased remarkably with notch orientation from 0 degrees to 90 degrees.
引用
收藏
页数:13
相关论文
共 50 条
  • [41] Experimental Investigation on the Quasi-static Penetration Behavior of Curved Multi-axial Warp-knitted Composites
    Gao, Zhe
    Ma, Pibo
    Jiang, Gaoming
    Cong, Honglian
    FIBERS AND POLYMERS, 2016, 17 (09) : 1497 - 1504
  • [42] Experimental investigation on the quasi-static penetration behavior of curved multi-axial warp-knitted composites
    Zhe Gao
    Pibo Ma
    Gaoming Jiang
    Honglian Cong
    Fibers and Polymers, 2016, 17 : 1497 - 1504
  • [43] Analysis of warp knitted fabric structure. Part V: experimental study on the initial modulus of warp knitted fabrics
    Dabiryan, H.
    Jeddi, Ali A. A.
    Rastgoo, A.
    JOURNAL OF THE TEXTILE INSTITUTE, 2013, 104 (01) : 46 - 56
  • [44] Mechanical Properties of Thermoplastic and Thermoset Composites Reinforced with 3D Biaxial Warp-knitted Fabrics
    Al-darkazali, Ali
    Colak, Pinar
    Kadioglu, Kemal
    Gunaydin, Erdinc
    Inanc, Ibrahim
    Demircan, Ozgur
    APPLIED COMPOSITE MATERIALS, 2018, 25 (04) : 939 - 951
  • [45] Effect of run-in ratios on the mechanical properties of two-guide bars warp-knitted fabrics
    Chen, Nanliang
    Journal of Dong Hua University (English Edition), 2000, 17 (03): : 87 - 89
  • [46] Preparation and bending properties of curved structure composite reinforced with multi-axial warp-knitted glass fabric
    Xu H.
    Liu C.
    Yang J.
    Gao X.
    Fuhe Cailiao Xuebao/Acta Materiae Compositae Sinica, 2023, 40 (08): : 4506 - 4516
  • [47] Investigation of the Mechanical Properties of Three-Dimensional Polyurethane Composites Reinforced with Warp-Knitted Spacer Fabrics
    Lou, Ge
    Chen, Si
    AATCC JOURNAL OF RESEARCH, 2022, 9 (05): : 231 - 239
  • [48] Study on mechanical properties of coated biaxial warp knitted fabrics
    Yang, Bin
    Yu, Zeliang
    IASS 60TH ANNIVERSARY SYMPOSIUM (IASS SYMPOSIUM 2019) - 9TH INTERNATIONAL CONFERENCE ON TEXTILE COMPOSITES AND INFLATABLE STRUCTURES (STRUCTURAL MEMBRANES 2019), 2019, : 2329 - 2335
  • [49] Mechanical Properties of Thermoplastic and Thermoset Composites Reinforced with 3D Biaxial Warp-knitted Fabrics
    Ali Al-darkazali
    Pınar Çolak
    Kemal Kadıoğlu
    Erdinç Günaydın
    Ibrahim Inanç
    Özgür Demircan
    Applied Composite Materials, 2018, 25 : 939 - 951
  • [50] Study on mechanical properties of coated biaxial warp knitted fabrics
    Yang, Bin
    Yu, Zeliang
    IASS Symposium 2019 - 60th Anniversary Symposium of the International Association for Shell and Spatial Structures; Structural Membranes 2019 - 9th International Conference on Textile Composites and Inflatable Structures, FORM and FORCE, 2019, : 2329 - 2335