Experimental evaluation of the effect of clamping force and hole clearance on carbon composites subjected to bearing versus bypass loading

被引：23

作者：

Rosales-Iriarte, F. ^{[1
]}

Fellows, N. A. ^{[1
]}

Durodola, J. F. ^{[1
]}

机构：

[1] Oxford Brookes Univ, SMART Grp, Sch Technol, Oxford OX33 1HX, England

来源：

COMPOSITE STRUCTURES | 2011年 / 93卷 / 03期

关键词：

Carbon composites; Bolted joints; Damage tolerance; Damage mechanics; BOLTED JOINTS; SINGLE-BOLT; STRENGTH; LAMINATE; BEHAVIOR; DAMAGE;

D O I：

10.1016/j.compstruct.2010.09.016

中图分类号：

O3 [力学];

学科分类号：

08 ; 0801 ;

摘要：

A series of carbon fibre laminate bearing versus bypass load tests were carried out investigating the effect of hole clearance, laminate lay-up, washer contact size and clamping force value. Explanations of the underlying effects that influence the results are discussed. The results compare well with literature but hole clearance was shown to increase joint strength when bypass loads are dominant, which seems counter intuitive, and has not been reported in literature. (C) 2010 Elsevier Ltd. All rights reserved.

引用

页码：1096 / 1102

页数：7

共 24 条

[1] THE EXPERIMENTAL BEHAVIOR OF BOLTED JOINTS IN PULTRUDED GLASS POLYESTER MATERIAL .1. SINGLE-BOLT JOINTS
ABDELNABY, SFM
HOLLAWAY, L
[J]. COMPOSITES, 1993, 24 (07): : 531 - 538
[2] Alaattin A, 2004, COMPOS SCI TECHNOL, V64, P1605
[3] Alaattin A, 2003, COMPOS STRUCT, V62, P107
[4] 3-DIMENSIONAL CONTACT STRESS-ANALYSIS OF A COMPOSITE LAMINATE WITH BOLTED JOINT
CHEN, WH
LEE, SS
YEH, JT
[J]. COMPOSITE STRUCTURES, 1995, 30 (03) : 287 - 297
[5] COMBINED BEARING AND BYPASS LOADING ON A GRAPHITE EPOXY LAMINATE
CREWS, JH
NAIK, RA
[J]. COMPOSITE STRUCTURES, 1986, 6 (1-3) : 21 - 40
[6] DINICOLA AJ, 1993, AM SOC TEST MATER, V1206, P220
[7] ON THE BEARING STRENGTH OF BOLTED GRAPHITE EPOXY LAMINATES
ERIKSSON, I
[J]. JOURNAL OF COMPOSITE MATERIALS, 1990, 24 (12) : 1246 - 1269
[8] Garbo SP, 1978, AFFDLTR78179
[9] Hart-Smith LJ, 1977, CR144899 NASA
[10] Hoa SV, 1994, J COMPOS TECH RES, V17, P125

← 1 2 3 →