Hydraulic-Fracture Propagation in a Naturally Fractured Reservoir

被引:75
作者
Chuprakov, D. A. [1 ]
Akulich, A. V. [1 ]
Siebrits, E. [2 ]
Thiercelin, M. [3 ]
机构
[1] Schlumberger Moscow Res, Moscow, Russia
[2] TerraTek, Salt Lake City, UT USA
[3] Schlumberger Reg Technol Ctr, Dallas, TX USA
来源
SPE PRODUCTION & OPERATIONS | 2011年 / 26卷 / 01期
关键词
BEDDING INTERFACES; RE-INITIATION; CRACK; DEFLECTION; BRITTLE;
D O I
10.2118/128715-PA
中图分类号
TE [石油、天然气工业];
学科分类号
0820 ;
摘要
We present the results of numerical modeling that quantify the physical mechanisms of mechanical activation of a natural fault because of contact with a pressurized hydraulic fracture (HF). We focus on three stages of interactions: HF approaching, contact, and subsequent infiltration of the fault. Fracture interaction at the contact is shown to depend on four dimensionless parameters: net pressure in the HF, in-situ differential stress, relative angle between the natural fault and the HF, and friction angle of the natural fault. A numerical model based on the displacement discontinuity method (DDM) allowing for fracture closure and Mohr-Coulomb friction was used to calculate the displacements and stresses along the natural fracture as a result of the interaction with the pressurized HF. The analysis of the total stress state along the fault during the HF coalescence stage makes it possible to define a criterion for reinitiation of a secondary tensile crack from the natural fault. We show that the most probable location for tensile-crack initiation is the end of the open zone of the fault where the highest tension peak is generated by the HF contact. In our numerical analysis, we study the magnitude of maximum tensile stress and its position along the fault for a wide range of key dimensionless parameters. Given real reservoir properties, these measurements can be used to detect the possible fracturing scenarios in naturally fractured reservoirs. Using simplified uncoupled modeling of fluid penetration into the fault after the contact with the HF, we demonstrate that either an increase or a decrease of the tensile stress at the opposite side of the fault can be realized depending on the ratio of increments of net pressure and the fluid front as it penetrates the natural fault.
引用
收藏
页码:88 / 97
页数:10
相关论文
共 34 条
[1]   Numerical Simulation of Hydraulic Fracture Crack Propagation [J].
Akulich, A. V. ;
Zvyagin, A. V. .
MOSCOW UNIVERSITY MECHANICS BULLETIN, 2008, 63 (01) :6-12
[2]  
[Anonymous], P UNC GAS TECHN S SO
[3]  
[Anonymous], 2009, SPE ANN TECHN C EXH, DOI DOI 10.2118/124919-MS
[4]  
[Anonymous], 2000, SPE AS PAC C INT MOD, DOI DOI 10.2118/59419-MS
[5]  
[Anonymous], P 6 INT C ROCK MECH
[6]  
Blanton T.L., 1982, EXPT STUDY INTERACTI
[7]   Interaction of dynamic mode-I cracks with inclined interfaces [J].
Chalivendra, V. B. ;
Rosakis, A. J. .
ENGINEERING FRACTURE MECHANICS, 2008, 75 (08) :2385-2397
[8]  
Christensen PW, 1998, INT J NUMER METH ENG, V42, P145, DOI 10.1002/(SICI)1097-0207(19980515)42:1<145::AID-NME358>3.0.CO
[9]  
2-L
[10]   MECHANISM FOR CONTROL OF CRACK PROPAGATION IN ALL-BRITTLE SYSTEMS [J].
COOK, J ;
EVANS, CC ;
GORDON, JE ;
MARSH, DM .
PROCEEDINGS OF THE ROYAL SOCIETY OF LONDON SERIES A-MATHEMATICAL AND PHYSICAL SCIENCES, 1964, 282 (1390) :508-+