High-Quality Sine Wave Generation Using a Differential Boost Inverter at Higher Operating Frequency

Buck-converter-based topologies are used to generate high-frequency sinusoidal outputs. Buck-based inversion circuits such as voltage source inverters or class-D amplifiers have inherent control-to-output linearity in large-signal sense. However, in these topologies, the instantaneous output is always smaller than the dc-input during linear modulation. A differential boost inverter (DBI) is a boost-based topology that is used to generate a sinusoidal output. In DBI, the instantaneous output can be higher or lower than the dc-input voltage. DBI exhibits nonlinear control-to-output behavior in large-signal dynamic sense. Therefore, generating a high-frequency sinusoidal output using this topology is a challenge. The issues associated with a DBI for high-frequency sine wave generation are characterized in this paper. Conventional linear and nonlinear control techniques fail to produce a high-quality sine wave output at higher operating frequency. A nonlinear feedback linearization technique is proposed, which forces the output to be linear with respect to the reference even at higher operating frequency. This leads to a high-frequency high-quality sine wave generation using a DBI. The proposed-modulator is verified using a laboratory prototype to generate a sine wave up to 2 kHz. A triangular wave of 100-Hz frequency is also generated by the proposed technique. Superior dynamic responses of a dynamic linearizing modulator controlled DBI for a step change in frequency, load current, input voltage, and reference are also experimentally verified.