Study of the structural, thermodynamic and cyclic effects of vanadium and titanium substitution in laves-phase AB2 hydrogen storage alloys

被引:57
|
作者
Ulmer, Ulrich [1 ]
Dieterich, Mila [2 ]
Pohl, Alexander [1 ]
Dittmeyer, Roland [3 ]
Linder, Marc [2 ]
Fichtner, Maximilian [1 ]
机构
[1] KIT, Inst Nanotechnol, POB 3640, D-76021 Karlsruhe, Germany
[2] German Aerosp Inst DLR, Inst Tech Thermodynam, Thermal Proc Technol, Pfaffenwaldring 38-40, D-70569 Stuttgart, Germany
[3] KIT, Inst Micro Proc Engn, POB 3640, D-76021 Karlsruhe, Germany
关键词
Ti sponge; Ferrovanadium; AB(2); Hydrogen storage; Cyclic properties; TI-V ALLOYS; GRAPHITE COMPOSITES; SOLID-SOLUTIONS; MN; HYDRIDE; MICROSTRUCTURE; ABSORPTION; OXYGEN;
D O I
10.1016/j.ijhydene.2017.06.137
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
The substitution of the high-purity and expensive raw materials vanadium (V) and titanium (Ti) by their low-cost, low-purity alternatives ferrovanadium (FeV) and Ti sponge in Ti0.98Zr0.02V0.43Fe0.09Cr0.05Mn1.5 was investigated and the microstructural, thermodynamic and cyclic properties were tested of these compounds. Four different samples were prepared and studied: one material prepared with high-purity V and Ti, a second one prepared with FeV in substitution for V and Fe, a third prepared with Ti sponge in substitution for Ti, and a fourth prepared with FeV and Ti sponge in substitution for V, Fe and Ti. The substitution of Ti with Ti sponge and of V and Fe by FeV had negligible effects on the micro structural properties. 2.0 mass% H were absorbed in both the pristine (high-purity V and Ti) material and after replacing Ti by Ti sponge. Substitution of V by FeV reduced the initial hydrogen absorption capacity to approximately 1.7 mass%. All materials exhibited equilibrium hydrogen absorption and dissociation pressures of ca. 1.5 MPa. They reversibly stored 1.8 mass% H for both the pristine and Ti-substituted samples and 1.6 mass% H after substitution of V and Fe by FeV or after substitution of V, Fe and Ti by FeV and Ti sponge, respectively. Long-term cyclic experiments over 1000 de-/hydrogenation pressure swing cycles were performed for the pristine material and after substitution of V, Fe and Ti by FeV and Ti sponge, respectively. Both materials exhibited similar activation and degradation behavior upon cycling. A reversible capacity of 1.5 mass% H was recorded for the pristine material after 1000 cycles, and 1.4 mass% H were reversibly stored in the material prepared with FeV and Ti sponge subjected to 1000 cycles. The raw material cost to store an equal amount of hydrogen can be reduced by 83% when V and Ti are substituted by FeV and Ti sponge. (C) 2017 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码:20103 / 20110
页数:8
相关论文
共 33 条
  • [31] First principles study of pressure induced structural phase transition in hydrogen storage material-MgH2
    Kanagaprabha, S.
    Asvinimeenaatci, A. T.
    Rajeswarapalanichamy, R.
    Iyakutti, K.
    PHYSICA B-CONDENSED MATTER, 2012, 407 (01) : 54 - 59
  • [32] Effects of spinning rate on structures and electrochemical hydrogen storage performances of RE-Mg-Ni-Mn-based AB2-type alloys
    Zhang, Yang-huan
    Zhang, Wei
    Song, Xi-ping
    Zhang, Pei-long
    Zhu, Yong-guo
    Qi, Yan
    TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA, 2016, 26 (12) : 3219 - 3231
  • [33] Pressure-induced structural stability of alkali trihydrides and H2-desorption occurrence: Ab initio study for hydrogen storage improvement
    Pluengphon, Prayoonsak
    Tsuppayakorn-aek, Prutthipong
    Inceesungvorn, Burapat
    Bovornratanaraks, Thiti
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2020, 45 (46) : 25065 - 25074