Mechanical properties of polymer composites based on commercial epoxy vinyl ester resin and glass fiber

被引:35
作者
da Silva, ALN
Teixeira, SCS
Widal, ACC
Coutinho, FMB
机构
[1] UFRJ, Inst Macromol Prof Eloisa Mano, BR-21945970 Rio De Janeiro, RJ, Brazil
[2] UERJ, Inst Politecn, Nova Friburgo, RJ, Brazil
[3] PETROBRAS, CENPES, Rio De Janeiro, RJ, Brazil
[4] UERJ, IQ, Dept Proc Ind, Rio De Janeiro, RJ, Brazil
关键词
thermosetting resin; composites; epoxy vinyl ester resin; mechanical properties;
D O I
10.1016/S0142-9418(01)00018-6
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
The effect of the addition of methyl ethyl ketone peroxide (MEKP) and cobalt naphthenate (CoNaph) on the mechanical behavior of epoxy vinyl ester resin (EVER) laminates has been investigated by using a factorial experimental design, in which the MEKP and NaphCo contents were varied. Previous results showed that there is an interaction effect between the process variables analysed on the mechanical properties evaluated. It was also observed that the MEKP/CoNaph ratio affected the tensile behavior of the EVER/glass fiber composites. (C) 2001 Elsevier Science Ltd. All rights reserved.
引用
收藏
页码:895 / 899
页数:5
相关论文
共 8 条
[1]  
KOK JMM, 1999, COMPOS PART A-APPL S, V30, P917
[2]   MICROGELATION IN THE CURING REACTION OF UNSATURATED POLYESTER RESINS [J].
LIU, SB ;
LIU, JL ;
YU, TL .
JOURNAL OF APPLIED POLYMER SCIENCE, 1994, 53 (09) :1165-1177
[3]  
Lubin B, 1984, HDB COMPOSITES
[4]  
May CA, 1988, EPOXY RESIN CHEM TEC
[5]   Mode I interlaminar fracture toughness properties of advanced textile fibreglass composites [J].
Mouritz, AP ;
Baini, C ;
Herszberg, I .
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 1999, 30 (07) :859-870
[6]  
Ramis X, 1997, J POLYM SCI POL PHYS, V35, P371, DOI 10.1002/(SICI)1099-0488(19970130)35:2<371::AID-POLB13>3.0.CO
[7]  
2-F
[8]   The influence of processing parameters on interphase morphology in polymer composites based on phase-separating thermoplast/epoxy blends [J].
Saalbrink, A ;
Lorteije, A ;
Peijs, T .
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 1998, 29 (9-10) :1243-1250