Effect of apex cone shape on fine particle classification of gas-cyclone

被引：65

作者：

Yoshida, Hideto ^{[1
]}

Nishimura, Yusuke ^{[1
]}

Fukui, Kunihiro ^{[1
]}

Yamamoto, Tetsuya ^{[1
]}

机构：

[1] Hiroshima Univ, Dept Chem Engn, Higashihiroshima 7398527, Japan

来源：

POWDER TECHNOLOGY | 2010年 / 204卷 / 01期

关键词：

Gas-cyclone; Particle separation; Cut size; Particle size; Sub-micron particles; AIR-CYCLONE; FLUID-FLOW;

D O I：

10.1016/j.powtec.2010.07.006

中图分类号：

TQ [化学工业];

学科分类号：

0817 ;

摘要：

The purpose of this paper is to study the effects of apex cone shape on particle separation performance of gas-cyclones by experiment and CFD studies. It is found that the optimum apex cone angle is 70 degrees. The minimum 50% cut size was obtained by use of this special apex cone. From the flow visualization method by use of soap foam, the upward flow and downward flow coexisted on the surface of this special apex cone. The clear interface between upward flow and downward flow was detected on the apex cone angle of 70 degrees. The effect of the apex cone angle on particle separation performance decreases under high inlet velocity conditions, because most particles are moving in the area away from the apex cone. The particle separation performance and flow visualization results qualitatively supported the 3-dimensional CFD simulation based on the direct method. (C) 2010 Elsevier B.V. All rights reserved.

引用

页码：54 / 62

页数：9

共 11 条

[1]

Iinoya K., 1993, POWDER PARTICLE, V11, P223, DOI DOI 10.14356/kona.1993025

[2]

KAWAMURA T, 1980, THESIS TOKYO U JAPAN

[3]

Kawamura T., 1984, AIAA Paper, Vvol 84, P0340

[4]

Patanker S., 1980, NUMERICAL HEAT TRANS, P113

[5]

Toei R., 1976, PRACTICE CHEM ENG PR, P148

[6] The effect of a new method of fluid flow control on submicron particle classification in gas-cyclones [J].

Yoshida, H ;

Ono, K ;

Fukui, K .

POWDER TECHNOLOGY, 2005, 149 (2-3) :139-147

[7] EFFECT OF BLOW-DOWN ON FLUID-FLOW AND PARTICLE MOVEMENT IN CYCLONE CLASSIFIER [J].

YOSHIDA, H ;

FUJIOKA, T ;

HASHIMOTO, K ;

NAGAHASHI, K .

KAGAKU KOGAKU RONBUNSHU, 1995, 21 (03) :594-602

[8] Elaborate classification of flyash particles by bench scale air cyclone [J].

Yoshida, H ;

Yamamoto, T ;

Okanishi, K ;

Morisaki, H ;

Nakamura, T ;

Iinoya, K .

KAGAKU KOGAKU RONBUNSHU, 1997, 23 (03) :363-370

[9] Effect of apex cone height on particle classification performance of a cyclone separator [J].

Yoshida, H ;

Kwan-Sik, Y ;

Fukui, K ;

Akiyama, S ;

Taniguchi, S .

ADVANCED POWDER TECHNOLOGY, 2003, 14 (03) :263-278

[10] FINE-PARTICLE SEPARATION BY REVISED TYPE AIR-CYCLONE CLASSIFIER [J].

YOSHIDA, H ;

SAEKI, T ;

FUJIOKA, T ;

UEDA, T ;

FUYUKI, T .

KAGAKU KOGAKU RONBUNSHU, 1993, 19 (03) :476-482

← 1 2 →