Modelling of the Hydraulic Work Roll Bending Control System of the Plate Rolling Mill

被引：0

作者：

Voronin, Stanislav S. ^{[1
]}

Gasiyarov, Vadim R. ^{[1
]}

Maklakova, Ekaterina A. ^{[1
]}

机构：

[1] Natl Res Univ, South Ural State Univ, Dept Mechatron & Automat, Chelyabinsk, Russia

来源：

PROCEEDINGS OF THE 2017 IEEE RUSSIA SECTION YOUNG RESEARCHERS IN ELECTRICAL AND ELECTRONIC ENGINEERING CONFERENCE (2017 ELCONRUS) | 2017年

关键词：

hot rolling; work roll bending rolling process; flatness; rolling force regulator;

D O I：

暂无

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

For modern hot rolling mills the typical hydraulic circuit was designed to control the roll bending force during rolling process. The most common operating modes of the roll bending system were studied: rolling, start and stop. The bending roll control system was designed in the form of functional blocks, connecting the actuators, sensors and sided subsystems of the rolling control. A functional diagram of the work bending, including of reference and actual values generation. A force regulator was made on the basis of signals from the pressure sensors and the actual effort. A simulation of the regulator were displayed for the main operation modes of the bending system.

引用

页码：1060 / 1063

页数：4

共 7 条

[1] [Anonymous], 2015, INT SIB C CONTR COMM
[2] Gasiyarov V. R., 2011, ALL RUSS MULT CONTR, V4, P307
[3] Gasiyarov V. R., 2012, TECHNOLOGY PRODUCTIO, P126
[4] Gasiyarov V. R., 2010, URALS SCI IND, P107
[5] The work roll bending control system of the hot plate rolling mill
Maklakova, E. A.
Maklakov, A. S.
Gasiyarov, V. R.
Voronin, S. S.
[J]. INTERNATIONAL CONFERENCE ON INDUSTRIAL ENGINEERING (ICIE-2015), 2015, 129 : 37 - 41
[6] Research of Electric Drive at Load Impact on Hot Plate Mill 5000
Radionov, A. A.
Maklakov, A. S.
Gasiyarov, V. R.
Maklakova, E. A.
[J]. 2015 INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING, AUTOMATION AND CONTROL SYSTEMS (MEACS), 2015,
[7] Radionov A. A., 2015, AUTOMATIC GAP CONTRO, P1

← 1 →