Optical and electronic properties of CrOxNy films, deposited by reactive DC magnetron sputtering in Ar/N2/O2(N2O) atmospheres

被引:36
作者
Mientus, R
Grötschel, R
Ellmer, K
机构
[1] Optotransmitter Umweltschutz Technol eV, D-12555 Berlin, Germany
[2] Hahn Meitner Inst Berlin GmbH, Dept Solar Energet, D-14109 Berlin, Germany
[3] Forschungszentrum Rossendorf EV, Dept Ion Beam Anal, D-01328 Dresden, Germany
关键词
chromium oxide; chromium nitride; reactive magnetron sputtering; electronic properties; discharge characteristics; MECHANICAL-PROPERTIES; CHROMIUM NITRIDE; THIN-FILMS;
D O I
10.1016/j.surfcoat.2005.02.181
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Chromium oxynitride films CrOxNy were prepared by reactive magnetron sputtering from a chromium target in Ar/O-2(N2O)/N-2 gas mixtures. The argon-to-nitrogen partial pressure ratio and the DC discharge power were kept constant in the experiments. By changing the gas composition the film stoichiometry can be continuously varied from CrN to Cr2O3. The film composition has been determined by Rutherford backscattering (RBS) and by elastic recoil detection analysis (ERDA). From an XRD analysis it was concluded that the films consist of CrN nanocrystals in an amorphous oxide matrix. Depending on the oxygen content [O], the electronic behaviour of the films changes, accompanied by the evolution of an optical band gap, which was determined by spectral transmission and reflection measurements. The (negative) temperature coefficient at approximate to 300 K of the resistivity of the films is in the range of 0.5 (CrN) to 2% K-1 (CrO0.5N0.7). This film property can be used for temperature-dependent resistors, for instance in thermal radiation detectors. (c) 2005 Elsevier B.V. All rights reserved.
引用
收藏
页码:341 / 345
页数:5
相关论文
共 12 条
[1]   Characterisation of chromium nitride films produced by PVD techniques [J].
Barata, A ;
Cunha, L ;
Moura, C .
THIN SOLID FILMS, 2001, 398 :501-506
[2]  
Bass J., 1982, LANDOLT B RNSTEIN GR, V15a, P5
[3]   The Berlin time-of-flight ERDA setup [J].
Bohne, W ;
Rohrich, J ;
Roschert, G .
NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION B-BEAM INTERACTIONS WITH MATERIALS AND ATOMS, 1998, 136 :633-637
[4]   Structural and mechanical properties of chromium nitride, molybdenum nitride, and tungsten nitride thin films [J].
Hones, P ;
Martin, N ;
Regula, M ;
Lévy, F .
JOURNAL OF PHYSICS D-APPLIED PHYSICS, 2003, 36 (08) :1023-1029
[5]   Characterization of sputter-deposited chromium oxide thin films [J].
Hones, P ;
Diserens, M ;
Lévy, F .
SURFACE & COATINGS TECHNOLOGY, 1999, 120 :277-283
[6]   On measurement of optical band gap of chromium oxide films containing both amorphous and crystalline phases [J].
Hong, S ;
Kim, E ;
Kim, DW ;
Sung, TH ;
No, K .
JOURNAL OF NON-CRYSTALLINE SOLIDS, 1997, 221 (2-3) :245-254
[7]   Electrical, optical and mechanical properties of sputtered CrNy and Cr1-xSixN1.02 thin films [J].
Martinez, E ;
Sanjinés, R ;
Banakh, O ;
Lévy, F .
THIN SOLID FILMS, 2004, 447 :332-336
[8]   Reactive magnetron sputtering of tin-doped indium oxide (ITO): influence of argon pressure and plasma excitation mode [J].
Mientus, R ;
Ellmer, K .
SURFACE & COATINGS TECHNOLOGY, 2001, 142 :748-754
[9]   Reactive DC magnetron sputtering of elemental targets in Ar/N2 mixtures:: relation between the discharge characteristics and the heat of formation of the corresponding nitrides [J].
Mientus, R ;
Ellmer, K .
SURFACE & COATINGS TECHNOLOGY, 1999, 116 :1093-1101
[10]   Graded selective coatings based on chromium and titanium oxynitride [J].
Nunes, C ;
Teixeira, V ;
Prates, ML ;
Barradas, NP ;
Sequeira, AD .
THIN SOLID FILMS, 2003, 442 (1-2) :173-178