Effects of powder size distribution on the microstructural and mechanical properties of a Co-Cr-W-Si alloy fabricated by selective laser melting

Co-Cr based alloys are recognized as one of the most widely used category of alloys amongst the biomedical materials. This is because these alloys show a high strength, corrosion resistance and good biocompatibility suitable for biomedical applications. Many researchers have been focused on the processing of these alloys using a selective laser melting process. The effects of different processing parameters on the obtained microstructural and mechanical properties of the processed parts have been investigated in these studies. However, the effect of powder distribution size (powder granulometry), as a primary processing parameter, on the microstructural and mechanical properties of Co-Cr alloys is not well investigated and studied so far. This study investigated the influence of this parameter, by using powders with the same composition and morphology but a different particle size of coarse and fine, on the microstructural and mechanical properties of as-built, homogenizing heat treated and homogenizing heat treated followed by subsequent aging treatment SLM fabricated Co28Cr9W1.5Si (wt.%) samples. X-ray diffraction, scanning electron microscopy, electron backscatter diffraction and transmission electron microscopy were used to characterize and identify the microstructure, phase composition and crystallographic information of the manufactured samples. Besides, the mechanical properties of samples, processed using powders having different size distributions, were measured using a tensile test machine and results were correlated to the microstructure of the samples. It was concluded that the powder granulometry has a negligible effect on the microstructural and mechanical properties of the as-built SLM Co-Cr-W-Si parts but a remarkable influence on those of the heat-treated ones. (C) 2020 Elsevier B.V. All rights reserved.