Correlation of the thermodynamic calculation and the experimental observation of Ni-Mo-Cr low alloy steel changing Ni, Mo, and Cr contents

SA508 Gr 4N Ni-Mo-Cr low alloy steel has Improved fracture toughness and strength compared to commercial low alloy steels such as SA508 Gr 3 Mn-Mo-Ni low alloy steel which has less than 1% Ni Higher strength and fracture toughness of low alloy steels can be achieved by increasing the Ni and Cr contents In this study the effects of the alloying elements of Ni and Cr on the microstructural characteristics and mechanical properties of SA508 Gr 4N NI-Mo-Cr low alloy steel are evaluated Changes in the stable phases of SA508 Gr 4N low alloy steel with these alloying elements were evaluated using thermodynamic calculation software These values were then compared with the observed microstructural results Additionally tensile tests and Charpy impact test were carried out to evaluate the mechanical properties The thermodynamic calculations show that Ni mainly affects the change of the matrix phase of gamma and alpha rather than the carbide phase Contrary to the Ni effect Cr and Mo primarily affect the precipitation behavior of the carbide phases of Cr(23)C(6) Cr(7)C(3) and Mo(2)C In the microscopic observations the lath martensitic structure becomes finer as the Ni content increases without affecting the carbides When the Cr content decreases the Cr carbide becomes unstable and carbide coarsening occurs Carbide Mo(2)C in the form of fine needles were observed in the high-Mo alloy Greater strength was obtained after additions of Ni and Mo and the transition properties were Improved as the Ni and Cr contents increased These results were correlated with the thermodynamic calculation results (C) 2010 Elsevier B V All rights reserved