Precision laser deburring and acoustic emission feedback

被引：14
作者：
Lee, SH [1 ]
Dornfeld, DA [1 ]
机构：
[1] Univ Calif Berkeley, Dept Mech Engn, Berkeley, CA 94720 USA
来源：
JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME | 2001年 / 123卷 / 02期
关键词：
D O I：
10.1115/1.1346689
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
Sensor feedback for process control in one of the essential elements in an automated deburring procedure. This paper presents the implementation of acoustic emission (AE), which has been developed as a feedback sensing techniques for precision (mechanical) deburring, in a precision laser deburring process. AE signals were sampled during laser machining/deburring under various experimental conditions and analyzed using several signals processing methods including AE rms and spectral analysis. The results, such as the sensitivity of AE signals to different laser cutting depths, edge detection capability and the frequency analysis show a clear correlation between physical process parameters and the AE signals. A subsequent control strategy for deburring automation is also briefly discussed.
引用
收藏
页码：356 / 364
页数：9
相关论文
共 28 条
  • [1] *AM SOC NOND TEST, 1987, NOND TEST HDB, V5
  • [2] BOLOTIN YI, 1976, WELD PROD+, V23, P28
  • [3] BORCHERS H, 1960, Z METALLKD, V51, P212
  • [4] Chin B. A., 1983, WELD J, V62, P227
  • [5] CHRYSSOLOURIS G, 1991, J ENG IND-T ASME, V113, P268, DOI 10.1115/1.2899696
  • [6] CHRYSSOLOURIS G, 1994, ANN CIRP, V43, P513
  • [7] CHRYSSOLOURIS G, 1990, LASER MACHINING
  • [8] ACOUSTIC-EMISSION MEASUREMENTS DURING ELECTRON-BEAM WELDING OF NICKEL-BASE ALLOYS
    DICKHAUT, E
    EISENBLATTER, J
    [J]. JOURNAL OF ENGINEERING FOR POWER-TRANSACTIONS OF THE ASME, 1975, 97 (01): : 47 - 52
  • [9] Dornfeld D., 1992, CIRP ANN-MANUF TECHN, V41, P93, DOI 10.1016/S0007-8506(07)61160-3
  • [10] GRAHAM LJ, 1974, MATER EVAL, V32, P31
123