Pore-filled nanotiltration membranes based on poly(2-acrylamido-2-methylpropanesulfonic acid) gels

Strong polyacid gel-filled membranes have been prepared by UV-initiated copolymerization of 2-acrylamido-2-methylpropanesulfonic acid (AMPS) and N,N'-methylenebisacrylamide within the pores of a microporous polypropylene (PP) substrate. These poly(2-acrylamido-2-methylpropanesulfonic acid) (PAMPS) gel-filled membranes were readily prepared with predictable amounts of the incorporated gel polymer (mass gain, MG) provided that threshold values of the degree of cross-linking and monomer concentration were exceeded. Most of the membranes showed large dimensional changes, particularly in their thickness on incorporation of the PAMPS. These changes were related to the amount of PAMPS incorporated into the membranes. In order to determine the polymer volume fractions of the incorporated gets, the partial specific volume of PAMPS (0.575 cm(3)/g) was obtained from density measurements using pycnometry. As a result of increase in thickness (volume) of the membranes, the polymer volume fractions of the PAMPS pore-filling gels were limited to values between 0.01 and 0.06, relatively low values compared to values achieved with other gel-filled membranes based on the same substrate. The Darcy permeability of PAMPS get-filled membranes exhibits a typical relationship with polymer volume fraction, but the absolute values obtained are much lower than those of other gel-filled membranes previously studied. The lower permeability could be attributed to tightly bound water molecules along polymer chains, which effectively enlarges the hydrodynamic size of polymer chains and narrows the channels for water transport. Using the sphere model based on the Odijk's theory of semidilute polyelectrolyte solutions, the Darcy permeability of PAMPS gel-filled membranes could be calculated with good precision. © 2005 Elsevier B.V. All rights reserved.