Evaluation of application techniques of fibrin sealant to prevent cerebrospinal fluid leakage: A new device for the application of aerosolized fibrin clue

OBJECTIVE: This report evaluates the sealing effects of fibrin sealant applied on the dura mater using different techniques. METHODS: Three application methods were studied: a sequential layer method, a simultaneous method using a cannula and a spray method using a newly developed spray device. The sealing effects of these methods were compared using in vitro histological analysis and a pressure resistance test. The clinical efficacy of the fibrin sealant to prevent water leakage through the dura mater was retrospectively analyzed in a total of 509 patients. The process of absorption of a clinically applied fibrin clot in vivo was examined using surgical specimens. RESULTS: The fibrin plate made using the spray method withstood a hydrostatic pressure greater than 200 cm H2O. A scanning electron microscopic study of the fibrin clots showed that the sequential and simultaneous methods produced a fibrin fiber network; in contrast, our spray method formed a dense fibrin tissue in which the fibrin molecules fused together forming stratified laminae. Of the 295 supratentorial craniotomies during which spraying was used, postsurgical cerebrospinal fluid leakage occurred in 9 cases (3.1%), whereas of the 214 craniotomies during which spraying was not used, cerebrospinal fluid leakage occurred in 19 cases (8.9%). Histological examinations of 10 surgical specimens obtained during second craniotomies revealed that the spray-made fibrin clots had been gradually replaced by mature granulation composed of collagenous connective tissue. CONCLUSION: The optimal technique for applying fibrin sealant is the spray method that aerosolizes fibrin glue and produces a tough fibrin plate.