Isothermal piston gas compression for compressed air energy storage

Currently, Compressed Air Energy Storage systems mainly use adiabatic compression. Compared with isothermal compression, approximately twice the electricity is transformed into heat. Twice the heat passed into heat exchange mediums leads to twice the heat transfer losses. Enhancement of the heat transfer between air and environment to achieve isothermal compression is an effective approach to improve the turnaround efficiency of CAES systems. An isothermal piston structure is proposed to do isothermal compression. One end of the isothermal piston is connected to a traditional piston, and the other end dips into a liquid medium in the bottom of a cylinder. This forms a gas-solid-liquid three-layer heat transfer structure. A porous medium is used to enhance the heat transfer from the air to the liquid. As the heat capacity of the liquid is much greater than that of the air, the temperature of the liquid remains unchanged as well as the compressed air. A new method is proposed to look at the thermodynamics of the compressor with two dimensionless parameters Ka and Xu. Ka describes the extent of the compressor approaching isothermal. When Ka is over 80, the temperature of the air is reduced by 80% compared with adiabatic condition. In the case of using an aluminum porous medium, the compression efficiency increases by 11% at the compression ratio of 7 and the speed of 1200 r/min. (C) 2020 Elsevier Ltd. All rights reserved.