Tire tread pattern design trigger on the stress distribution over rigid surfaces and soil compaction

被引:24
作者
Barbosa, Luis A. P. [1 ]
Magalhaes, Paulo S. G. [1 ]
机构
[1] Univ Estadual Campinas, Fac Agr Engn, BR-13083875 Campinas, SP, Brazil
关键词
Tire structure; Tread pattern; Structural stiffness; Stress distribution; Soil compaction; Soil bin; SUGARCANE SACCHARUM-OFFICINARUM; WHEEL LOAD; INFLATION PRESSURE; VERTICAL STRESS; RESISTANCE; AUSTRALIA; INTERFACE; TRACTOR; HARVEST;
D O I
10.1016/j.jterra.2014.12.006
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
Studies comparing the structural differences of tires have not qualitatively or quantitatively considered the effects of tread geometry on tire behaviour or the interactions of the tire with the surface. Therefore, to determine the effects of different tire tread patterns on the stress distribution of the tire and soil compaction, we compared the structural behaviours of a high-flotation tractive-tread (TT) tire and a smooth-tread (ST) tire. The experiments were conducted over a rigid and over a deformable surface. The results from the rigid surface shows the influences of the tread pattern and sidewalls is dependent of the loads. Over the deformable surface, the contact area of the TT tire was larger than that of the ST tire. The inflation pressure (IP) was mainly responsible for the load support before the soil reached its maximum deformation. Next, the tread and sidewalls exhibited the same behaviour as observed on the rigid surface. In addition, we observed alterations in the balloon point with the tread geometry and the type of surface due to changes in the contact pressure. With carcass deformation, the volume of the tire was visibly reduced, which indicated that the IP could increase. (C) 2015 ISTVS. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码:27 / 38
页数:12
相关论文
共 31 条
[1]  
[Anonymous], 2002, REV BRAS ENG AGR AMB, DOI [DOI 10.1590/S1415-43662002000200024, 10.1590/S1415-43662002000200024]
[2]   Soil stress as affected by wheel load and tyre inflation pressure [J].
Arvidsson, Johan ;
Keller, Thomas .
SOIL & TILLAGE RESEARCH, 2007, 96 (1-2) :284-291
[3]  
ASABE, 2009, ASAE EP542 FEB1999 R
[4]  
ASAE, 2004, STAND SOIL CON PEN
[5]  
ASTM International, 2007, D609107 ASTM INT, P13
[6]   Soil compaction produced by tractor with radial and cross-ply tyres in two tillage regimes [J].
Botta, G. F. ;
Rivero, D. ;
Tourn, M. ;
Melcon, F. Bellora ;
Pozzolo, O. ;
Nardon, G. ;
Balbuena, R. ;
Becerra, A. Tolon ;
Rosatto, H. ;
Stadler, S. .
SOIL & TILLAGE RESEARCH, 2008, 101 (1-2) :44-51
[7]   Agricultural traffic: Motion resistance and soil compaction in relation to tractor design and different soil conditions [J].
Botta, G. F. ;
Tolon-Becerra, A. ;
Tourn, M. ;
Lastra-Bravo, X. ;
Rivero, D. .
SOIL & TILLAGE RESEARCH, 2012, 120 :92-98
[8]   Traffic control and tillage strategies for harvesting and planting of sugarcane (Saccharum officinarum) in Australia [J].
Braunack, M. V. ;
McGarry, D. .
SOIL & TILLAGE RESEARCH, 2006, 89 (01) :86-102
[9]   Effect of harvest traffic position on soil conditions and sugarcane (Saccharum officinarum) response to environmental conditions in Queensland, Australia [J].
Braunack, M. V. ;
Arvidsson, J. ;
Håkansson, I. .
SOIL & TILLAGE RESEARCH, 2006, 89 (01) :103-121
[10]   Changes in soil cone resistance due to cotton picker traffic during harvest on Australian cotton soils [J].
Braunack, M. V. ;
Johnston, D. B. .
SOIL & TILLAGE RESEARCH, 2014, 140 :29-39