Effect of heat treatment on microstructure and properties of semi-solid squeeze casting AZ91D

Semi-solid AZ91D magnesium alloy billets were prepared by near-liquidus heat holding. Semi-solid squeeze casting was conducted at 575, 585 and 595 degrees C, respectively, with 1 mm center dot s(-1)squeeze speed. The semisolid squeeze casting AZ91D samples were heat treated by T4 (solution at 415 degrees C for 24 h) and T6 (solution at 415 degrees C for 24 h + 220 degrees C for 8 h) processes, respectively. The microstructure and mechanical properties of the alloy in different states were investigated by means of OM, SEM and tensile testing machine. The results show that compared to as-cast alloy, the grain size of the semi-solid squeezed AZ91D decreased significantly, and with the increase of semi-solid squeeze temperature, the grain size of AZ91D increased. The grains of the alloy were refined by T4 treatment, and further refined by T6 treatment. T6 treatment greatly improved the tensile strength, elongation, and hardness, but did not significantly improve yield strength. After 575 degrees C squeeze casting and T6 treatment, the ultimate tensile strength (UTS) reached 285 MPa, the elongation reached 13.36%, and the hardness also reached the maximum (106.8 HV), but the yield strength (YS) was only 180 MPa. During the process of semi-solid squeeze casting and heat treatment, the matrix grain was refined and a large number of precipitated and secondary precipitated phases of Mg(17)Al(12)appeared. Both the average size of matrix grain and secondary precipitated phase decreased, while the volume fraction of secondary precipitated phase increased. All these resulted in high tensile strength, elongation and hardness.