Dynamical and structural aspects of the cold crystallization of poly(dimethylsiloxane) (PDMS)

被引:95
作者
Lund, Reidar [1 ]
Alegria, Angel [2 ]
Goitandia, Luis [2 ]
Colmenero, Juan [1 ,2 ]
Gonzalez, Miguel A. [3 ,4 ]
Lindner, Peter [3 ]
机构
[1] Donostia Int Phys Ctr, Donostia San Sebastian 20018, Spain
[2] Ctr Mixto CSIC UPV EHU, Ctr Fis Mat, Dept Fis Mat, San Sebastian 20018, Spain
[3] Inst Max Von Laue Paul Langevin, F-38042 Grenoble, France
[4] Univ Zaragoza, Inst Ciencia Mat Aragon, CSIC, E-50009 Zaragoza, Spain
关键词
D O I
10.1021/ma702055b
中图分类号
O63 [高分子化学(高聚物)];
学科分类号
070305 ; 080501 ; 081704 ;
摘要
A detailed study of the dynamical and structural aspects of the cold crystallization behavior of highly flexible poly(dimethylsiloxane)(PDMS) is presented. In order to understand the complete behavior, before, under and after crystallization, a wide range of experimental techniques have been employed. A particular emphasis is made on the interplay between dynamical and structural effects and how the properties of the amorphous phase evolve during the crystallization. This is highlighted by combining mobility sensitive techniques, involving broadband dielectric spectroscopy (BDS) and differential scanning calorimetry, with neutron scattering: wide and small-angle neutron scattering (WANS/SANS) which are sensitive to the relative ordering of the atoms. In this way, we are able to compare the structure associated with crystal formation with the evolution and modification of the amorphous phase. The kinetics deduced from WANS points toward a classical nucleation and growth behavior closely following a Avrami-like growth with an exponent of about n = 3 which is expected for athermal nucleation from fixed centers followed by three-dimensional crystal growth. Furthermore, the amorphous phase (deduced from BDS) decays in parallel with the emergence of the crystalline phase (from WANS/SANS) without any shift in the characteristic relaxation time. However a careful comparison of the crystallization at short times indicates that the amorphous phase seems to be affected before any measurable crystallization is detected by WANS. Although this might be compatible with the existence of mesomorphic phase, it may also be attributed to more simple precursors as initial crystalline "baby-like" nuclei. In this picture, these crystalline nuclei may be formed homogeneously in the system which in turn causes a constraint on the surrounding chains connected to these crystalline nuclei. This is manifested as a distinct relaxation contribution that is drastically slower and heterogeneous than the conventional amorphous (x-relaxation of the melt. It would also explain a signal in SANS before any accompanying crystallization signal in WANS. Once the crystal starts developing, the fraction of the slower amorphous phase (constrained amorphous phase, CAP) grows and the conventional amorphous phase gradually disappears. At the very end the growing crystalline fronts start to overlap and some of the remaining CAP becomes even more constrained due to cross-link strongly manifested in both the dielectric response and the heat capacity.
引用
收藏
页码:1364 / 1376
页数:13
相关论文
共 50 条
  • [41] Investigation on coating methods of a self-assembled monolayer on PDMS (poly(dimethylsiloxane)) surface
    Park, Byongson
    Song, Simon
    BIOCHIP JOURNAL, 2007, 1 (02) : 140 - 143
  • [42] Mechanically Induced Hydrophobic Recovery of Poly(dimethylsiloxane) (PDMS) for the Generation of Surfaces with Patterned Wettability
    Mazaltarim, Ali J.
    Taylor, Jay M.
    Konda, Abhiteja
    Stoller, Michael A.
    Morin, Stephen A.
    ACS APPLIED MATERIALS & INTERFACES, 2019, 11 (36) : 33452 - 33457
  • [43] Structural analysis of poly(dimethylsiloxane) modified silica xerogels
    Guo, L
    Hyeon-Lee, JG
    Beaucage, G
    JOURNAL OF NON-CRYSTALLINE SOLIDS, 1999, 243 (01) : 61 - 69
  • [44] SILICA POLY(DIMETHYLSILOXANE) MIXTURES - NMR APPROACH TO THE CRYSTALLIZATION OF ADSORBED CHAINS
    EBENGOU, RH
    COHENADDAD, JP
    POLYMER, 1994, 35 (14) : 2962 - 2969
  • [45] Mechanical property of poly(dimethylsiloxane) (PDMS) reinforced with nanosheets of modified graphene oxide (MGO)
    Zhang, Yan
    Lin, Gui
    Zhu, Yanwu
    Ruoff, Rodney S.
    Mark, James E.
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2011, 242
  • [46] STRUCTURAL AND THERMODYNAMIC STUDY OF DIMETHYLSILOXANE-ETHYLENE OXIDE PDMS-PEO-PDMS TRIBLOCK CO-POLYMERS
    GALIN, M
    MATHIS, A
    MACROMOLECULES, 1981, 14 (03) : 677 - 683
  • [47] Cyclic poly(dimethylsiloxane) via ring-closing dehydrocoupling of α,ω-dihydroxy-PDMS with α,ω-dihydrido-PDMS in dilute solution
    Foston, Marcus
    Beckham, Haskell W.
    POLYMER, 2010, 51 (12) : 2515 - 2519
  • [48] Soft lithography of ceramic microparts using wettability-tunable poly(dimethylsiloxane) (PDMS) molds
    Su, Bo
    Zhang, Aijun
    Meng, Junhu
    Zhang, Zhaozhu
    JOURNAL OF MICROMECHANICS AND MICROENGINEERING, 2016, 26 (07)
  • [49] Amphiphilic block copolymer/poly(dimethylsiloxane) (PDMS) blends and nanocomposites for improved fouling-release
    Martinelli, Elisa
    Suffredini, Marianna
    Galli, Giancarlo
    Glisenti, Antonella
    Pettitt, Michala E.
    Callow, Maureen E.
    Callow, James A.
    Williams, David
    Lyall, Graeme
    BIOFOULING, 2011, 27 (05) : 529 - 541
  • [50] Writing Wrinkles on Poly(dimethylsiloxane) (PDMS) by Surface Oxidation with a CO2 Laser Engraver
    Qi, Lin
    Ruck, Cody
    Spychalski, Griffin
    King, Brian
    Wu, Benxin
    Zhao, Yi
    ACS APPLIED MATERIALS & INTERFACES, 2018, 10 (04) : 4295 - 4304