The preparation and morphological investigation of polyacrylonitrile electrospun nanofibre with different loading of carbon nanotube

被引：0

作者：

Munajat, N. A. ^{[1
]}

Nurfaizey, A. H. ^{[1
,2
]}

Fadzullah, S. H. S. M. ^{[1
,2
]}

机构：

[1] Univ Tekn Malaysia Melaka, Fac Mech Engn, Durian Tunggal 76100, Melaka, Malaysia

[2] Univ Tekn Malaysia Melaka, Ctr Adv Res Energy, Durian Tunggal 76100, Melaka, Malaysia

来源：

1ST COLLOQUIUM PAPER: ADVANCED MATERIALS AND MECHANICAL ENGINEERING RESEARCH (CAMMER'18) | 2018年

关键词：

Electrospinning; nanofibre; polyacrylonitrile; carbon nanotube;

D O I：

暂无

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Polyacrylonitrile (PAN) electrospun nanofibres with different loading of multi-walled carbon nanotube (MWCNT) were successfully prepared using electrospinning method. PAN powder was dissolved in dimethylformamide and the solution was electrospun under constant electrospinning parameters. The morphological structure and average fibre diameter of the nanofibres were examined using electron scanning microscopy. It was found that the solution with a higher content of MWCNT produced fibres with thicker fibre diameter. It was also observed that the surfaces of the fibres were rougher compared to control fibres. The results suggest that the inclusion of MWCNT reduced the electrospinnability of the PAN polymer solution.

引用

页码：69 / 70

页数：2

共 5 条

[1] Polyacrylonitrile/Carbon Nanotube Composite Films [J].

Guo, Huina ;

Minus, Marilyn L. ;

Jagannathan, Sudhakar ;

Kumar, Satish .

ACS APPLIED MATERIALS & INTERFACES, 2010, 2 (05) :1331-1342

[2]

Munajat N. A., 2017, FABRICATION CHARACTE, P1

[3] Polyacrylonitrile-based nanofibers A state-of-the-art review [J].

Nataraj, S. K. ;

Yang, K. S. ;

Aminabhavi, T. M. .

PROGRESS IN POLYMER SCIENCE, 2012, 37 (03) :487-513

[4]

Nurfaizey AH, 2012, WOODHEAD PUBL SER TE, P236

[5]

Pandey J.K., 2015, HDB POLYM NANOCOMPOS, VC.

← 1 →