Experimental evaluation of the operating temperature impact on solid oxide anode-supported fuel cells

Solid oxide fuel cells (SOFCs) seem to be a promising technology for the energy generation of tomorrow. Such devices are very complex and performances are strictly dependent on the understanding of basic concepts and development of new materials. The actual demonstrated target of SOFCs is around 1 W/cm(2) of power density at the operating temperature of 750 degrees C and practical fuel utilization (>50%); the goal for the next years is to reach 2 W/cm(2) at 650 degrees C of power density. The achievement of this goal depends mainly on the investigation of high-performance materials and on the developing of diagnostic and analytical techniques to deeply understand the cells' behaviour; moreover, the improvement of performance is strictly related to the manufacturing processes. In this paper is shown a study dealing with a comparison of two planar anode-supported SOFCs differing for cathode materials. in fact it is known that cathode overvoltage is a limiting factor for such cells' design. Tests were performed on SOFCs of anode-supported design at L.A.Q. IN.TE.S.E. In the paper, results are presented concerning the characterization of planar circular-shaped cells from InDEC (R) with lanthanum strontium manganite (LSM) and lanthanum strontium cobalt ferrite oxide (LSCF) cathodes. It is shown that cell performance can be increased via material selection; in fact, the power density of around 0.8 W/cm(2) is reached at 850 degrees C for the cell with LSM cathode and at 750 degrees C for the cell with LSCF cathode. (C) 2008 International Association for Hydrogen Energy. Published by Elsevier Ltd. All rights reserved.