Anti-fouling and scratch resistant hybrid sol-gel coatings

被引：0

作者：

Pahkala, Anne ^{[1
]}

Mannila, Julia ^{[1
]}

Kallio, Marke ^{[1
]}

Nikkola, Juha ^{[1
]}

Mahiout, Amar ^{[2
]}

Siivinen, Jarmo ^{[2
]}

Ritschkoff, Anne-Christine ^{[2
]}

Mahlberg, Riitta ^{[2
]}

Posti, Olli ^{[2
]}

Loija, Mia ^{[2
]}

Takala, Soili ^{[2
]}

机构：

[1] VTT Tech Res Ctr Finland, Sinitaival 6,POB 1000, FI-33101 Tampere, Finland

[2] VTT Tech Res Ctr Finland, FI-02044 Espoo, Finland

来源：

APPLIED MATERIAL RESEARCH AT VTT | 2006年

关键词：

D O I：

暂无

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

All surfaces are exposed to fouling, wearing and other degrading environmental effects during their lifetime. Continuous cleaning and repairing of surfaces causes financial losses and shutdowns in industrial processes. The aim of this study was to develop anti-fouling and scratch resistant hybrid sol-gel coatings for metal surfaces. Two different hybrid sol-gel coatings were prepared from modified solutions of silicon based alkoxides and coated on stainless steel by using spill and spray coating techniques. Anti-fouling properties were studied with contact angle measurements, fouling tests and FTIR scanning analysis. Abrasion properties were measured with pin-on-disk test and with an abrasive washing test (modified DIN 53778, Erichsen). Coatings were characterized with SEM and optical microscopy. According to performed anti-fouling tests, the cleanability of the anti-fouling sol-gel coated steel was enhanced compared to the uncoated steel surface. Measured water and oil contact angles were higher on the coated surface and the coated surface was not tainted. The abrasion tests showed that the scratch resistant coating abraded only slightly when the uncoated steel was abraded under the same load on a large scale.

引用

页码：177 / +

页数：2

共 5 条

[1] Commercial applications of sol-gel-derived hybrid materials [J].

Arkles, B .

MRS BULLETIN, 2001, 26 (05) :402-+

[2] Mechanical properties and adhesion characteristics of hybrid sol-gel thin films [J].

Atanacio, AJ ;

Latella, BA ;

Barbé, CJ ;

Swain, MV .

SURFACE & COATINGS TECHNOLOGY, 2005, 192 (2-3) :354-364

[3]

Brinker C.J., 1990, SOL GEL SCI

[4] Abrasion-resistant coatings for plastic and soft metallic substrates by sol-gel reactions of a triethoxysilylated diethylenetriamine and tetramethoxysilane [J].

Li, CH ;

Jordens, K ;

Wilkes, GL .

WEAR, 2000, 242 (1-2) :152-159

[5] Increasing hydrophobicity of sol-gel hard coatings by chemical and morphological modifications [J].

Wu, LYL ;

Soutar, AM ;

Zeng, XT .

SURFACE & COATINGS TECHNOLOGY, 2005, 198 (1-3) :420-424

← 1 →