Measurements of 186Re production cross section induced by deuterons on natW target at ARRONAX facility
被引:8
作者:
Guertin, Arnaud
论文数: 0引用数: 0
h-index: 0
机构:
Univ Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, FranceUniv Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Guertin, Arnaud
[1
]
Duchemin, Charlotte
论文数: 0引用数: 0
h-index: 0
机构:
Univ Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, FranceUniv Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Duchemin, Charlotte
[1
]
Haddad, Ferid
论文数: 0引用数: 0
h-index: 0
机构:
Univ Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
GIP Arronax, F-44817 St Herblain, FranceUniv Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Haddad, Ferid
[1
,2
]
Michel, Nathalie
论文数: 0引用数: 0
h-index: 0
机构:
GIP Arronax, F-44817 St Herblain, FranceUniv Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Michel, Nathalie
[2
]
Metivier, Vincent
论文数: 0引用数: 0
h-index: 0
机构:
Univ Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, FranceUniv Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Metivier, Vincent
[1
]
机构:
[1] Univ Nantes, EMN, IN2P3, Lab SUBATECH 1,CNRS, 4 Rue Alfred Kastler, F-44307 Nantes, France
Introduction: The ARRONAX cyclotron, acronym for "Accelerator for Research in Radiochemistry and Oncology at Nantes Atlantique" is a new facility installed in Nantes, France. A dedicated program has been launched on production of innovative radioisotopes for PET imaging and for beta- and alpha targeted radiotherapy using protons or a particles. Since the accelerator is also able to deliver deuteron beams up to 35 MeV, we have reconsidered the possibility of using them to produce medical isotopes. Indeed, in some cases, the use of deuterons allows higher production yield than protons. Methods: Re-186 is a beta- emitter which has chemical properties close to the widely used Tc-99m and has been used in clinical trials for palliation of painful bone metastases resulting from prostate and breast cancer. Re-186 production cross section has been measured between 9 and 23 MeV using the ARRONAX deuteron beam and the stacked-foil technique. A novelty in our work is the use of a monitor foil behind each W-nat target foil in order to record efficiently the deuteron incident flux and energies all over the stack relying on the International Atomic Energy Agency (IAEA) recommended cross section of the Ti-nat(d,x) V-48 reaction. Since a good optimization process is supposed to find the best compromise between production yield and purity of the final product, isotope of interest and contaminants created during irradiation are measured using gamma spectrometry. Results: Our new sets of data are presented and compared with the existing ones and with results given by the TALYS code calculations. The thick target yield (TTY) has been calculated after the fit of our experimental values and compared with the IAEA recommended ones. Conclusions: Presented values are in good agreement with existing data. The deuteron production route is clearly the best choice with a TTY of 7.8 MB/mu Ah at 30 MeV compared to 2.4 MBq/mu Ah for proton as projectile at the same energy. The TALYS code gives satisfactory results for 183,186Re isotopes. (C) 2014 Elsevier Inc. All rights reserved.