On the importance of thermo-elastic cooling in the fracture of glassy polymers at high rates

In a previous thermo-mechanical analysis [Estevez, R., Basu, S., van der Giessen, E., 2005. Analysis of temperature effects near mode I cracks in glassy polymers. Int. J. Fract. 132, 249-273] in which shear yielding of the bulk and failure by crazing were accounted for, we examined which of these two viscoplastic processes contributed to heat in mode I fracture. The present study completes this work by investigating the conditions for thermo-elastic cooling prior to crack propagation as reported experimentally by Rittel [Rittel, D., 1998. Experimental investigation of transient thermo-elastic effects in dynamic fracture. Int. J. Solids Struct. 35, 2959-2973] and Bougaut and Rittel [Bougaut, O., Rittel, D., 2001. On crack tip cooling during dynamic crack propagation. Int. J. Solids Struct. 38, 2517-2532] on high strain rate loading of PMMA. To this end, coupled thermo-mechanical finite element. simulations are carried out by accounting for the thermo-elastic source, in addition to the heat sources related to shear yielding and crazing. The bulk as well as cohesive zone parameters for crazing realistically describe PMMA as they are obtained from detailed calibration experiments. Our results show that if significant thermo-elastic cooling has to be observed in the vicinity of the crack tip of a polymeric material, suppression of shear yielding as well as suppression of crazing is necessary. It seems that at these high strain rates a brittle fracture mechanism activated at very high stresses takes over from crazing, or at least that craze initiation occurs for stress levels very different to those for quasi-static conditions. (C) 2008 Elsevier Ltd. All rights reserved.