Burr Formation in Drilling Intersecting Holes

被引：3

作者：

Leitz, L. ^{[1
]}

Franke, V. ^{[1
]}

Aurich, J. C. ^{[1
]}

机构：

[1] Univ Kaiserslautern, Inst Mfg Technol & Prod Syst, D-67653 Kaiserslautern, Germany

来源：

BURRS - ANALYSIS, CONTROL AND REMOVAL: PROCEEDINGS OF THE CIRP INTERNATIONAL CONFERENCE ON BURRS, 2009 | 2010年

关键词：

Drilling; Burrs; Intersecting holes;

D O I：

10.1007/978-3-642-00568-8_11

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The increasing power density in engine manufacturing as well as the complexity of parts in automotive production demand for an entire control of burr formation especially in regard of intersecting holes. This paper presents an approach to control burr formation concerning reproducible generation of burrs depending on intersecting geometry and process parameters. Therefore two process models describing burr formation and burr cap formation and results of experimental investigations of different workpiece materials (AISI 4140H (42CrMo4), 226D AlSi9Cu3)) were combined.

引用

页码：99 / 105

页数：7

共 6 条

[1] AURICH JC, 2004, WB WERKSTATT BETRIEB, V137, P44
[2] Aurich JC, 2006, SPANSAUBER UNTERSUCH
[3] Burr formation in intersecting holes
Heisel U.
Schaal M.
[J]. Production Engineering, 2008, 2 (1) : 55 - 62
[4] Min S., 2001, THESIS U CALIFORNIA
[5] Influence of exit surface angle on drilling burr formation
Min, SK
Dornfeld, DA
Nakao, Y
[J]. JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME, 2003, 125 (04): : 637 - 644
[6] PARK IW, 1996, THESIS U CALIFORNIA

← 1 →