A study on nucleate boiling heat transfer characteristics of pentane and CuO-pentane nanofluid on smooth and milled surfaces

被引:24
作者
Umesh, V. [1 ]
Raja, B. [1 ]
机构
[1] Indian Inst Informat Technol Design & Mfg IIITD&M, Madras 600127, Tamil Nadu, India
关键词
Milled surface; Nanofluid; Heat transfer coefficient; Nucleate boiling; Enhancement; NANO-FLUIDS; POOL; LIQUID; ORIENTATION; ROUGHNESS; ARRAYS; FC-72; PLAIN; CHIP;
D O I
10.1016/j.expthermflusci.2015.01.016
中图分类号
O414.1 [热力学];
学科分类号
摘要
Nucleate boiling heat transfer characteristic of pentane and CuO-pentane nanofluid is studied on smooth and enhanced circular brass surfaces of 20 mm diameter. The study is carried out at a pressure of 1 bar for the heat flux ranging between 1 and 10 W cm(-2). The measured experimental heat transfer coefficient of pure pentane on the smooth brass surface is validated against established correlation within acceptable limits of 5%. Further, two enhanced surfaces are prepared from plain surfaces by grooving in two perpendicular directions with pitches of 1 and 1.5 mm surfaces, which are named as fine and coarse surfaces respectively. Also, the effect of surface material on boiling is studied on similar enhanced surfaces made of steel, where the brass surfaces showed a 20-30% higher heat transfer coefficient for the tested condition. Further, the presence of nano-particle in the base fluid influence the heat transfer coefficient and the enhancement due to its presence is seen to be higher for lower volume fraction nanofluid. (C) 2015 Elsevier Inc. All rights reserved.
引用
收藏
页码:23 / 29
页数:7
相关论文
共 28 条
[1]   Effect of inclination on saturation boiling of PF-5060 dielectric liquid on 80- and 137-μm thick copper micro-porous surfaces [J].
Ali, Amir F. ;
El-Genk, Mohamed S. .
INTERNATIONAL JOURNAL OF THERMAL SCIENCES, 2012, 53 :42-48
[2]   Spreaders for immersion nucleate boiling cooling of a computer chip with a central hot spot [J].
Ali, Amir F. ;
El-Genk, Mohamed S. .
ENERGY CONVERSION AND MANAGEMENT, 2012, 53 (01) :259-267
[3]   Microelectronic Cooling by Enhanced Pool Boiling of a Dielectric Fluorocarbon Liquid [J].
Anderson, T. M. ;
Mudawar, I. .
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME, 1989, 111 (1-4) :752-759
[4]   Enhancement of pool boiling critical heat flux in dielectric liquids by microporous coatings [J].
Arik, Mehmet ;
Bar-Cohen, Avram ;
You, Seung Mun .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2007, 50 (5-6) :997-1009
[5]   Boiling heat transfer performance and phenomena of Al2O3-water nano-fluids from a plain surface in a pool [J].
Bang, IC ;
Chang, SH .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2005, 48 (12) :2407-2419
[6]   Nucleation site density in pool boiling of saturated pure liquids: Effect of surface microroughness and surface and liquid physical properties [J].
Benjamin, RJ ;
Balakrishnan, AR .
EXPERIMENTAL THERMAL AND FLUID SCIENCE, 1997, 15 (01) :32-42
[7]  
Borishansky V.M., 1969, PROBLEMS HEAT TRANSF, P16, DOI DOI 10.1016/B978-0-08-012077-5.50008-7
[8]   Enhanced boiling heat transfer from microporous surfaces: effects of a coating composition and method [J].
Chang, JY ;
You, SM .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 1997, 40 (18) :4449-4460
[9]   Nucleate boiling of water from plain and structured surfaces [J].
Das, A. K. ;
Das, P. K. ;
Saha, P. .
EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2007, 31 (08) :967-977
[10]   Pool boiling characteristics of nano-fluids [J].
Das, SK ;
Putra, N ;
Roetzel, W .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2003, 46 (05) :851-862