Fabrication of wire saw with patterned hard bumps by electrical discharge machining with powder suspended in working oil

被引：4
作者：
Furutani, Katsushi [1 ]
Murase, Yasuo [1 ]
机构：
[1] Toyota Technol Inst, Dept Adv Sci & Technol, Fac Engn, Nagoya, Aichi 468, Japan
来源：
MANUFACTURING SYSTEMS AND TECHNOLOGIES FOR THE NEW FRONTIER | 2008年
关键词：
slicing; deposition; titanium carbide;
D O I：
10.1007/978-1-84800-267-8_73
中图分类号：
F [经济];
学科分类号：
02 ;
摘要：
This paper deals with a fabrication method of a wire saw by electrical discharge machining (EDM). Hard bumps were discretely patterned on the surface of a thin stainless steel wire by EDM with titanium powder suspended in working oil. With an increase of the machining time, the average of the bump height was increased and no removal was observed. The bumps were deposited from four directions in an orthogonal sequence by manually turning the wire. A soda lime glass rod could be cut with the wire saw. The bumps tightly adhered on the wire.
引用
收藏
页码：361 / 364
页数：4
相关论文
共 13 条
  • [1] Development of a high-speed manufacturing method for electroplated diamond wire tools
    Chiba, Y
    Tani, Y
    Enomoto, T
    Sato, H
    [J]. CIRP ANNALS-MANUFACTURING TECHNOLOGY, 2003, 52 (01): : 281 - 284
  • [2] Fixed abrasive diamond wire machining - part I: process monitoring and wire tension force
    Clark, WI
    Shih, AJ
    Hardin, CW
    Lemaster, RL
    McSpadden, SB
    [J]. INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE, 2003, 43 (05) : 523 - 532
  • [3] Enomoto T, 1999, CIRP ANN-MANUF TECHN, V48, P273, DOI [10. 1016/S0007-8506(07)63182-5, DOI 10.1016/S0007-8506(07)63182-5]
  • [4] Accretion of titanium carbide by electrical discharge machining with powder suspended in working fluid
    Furutani, K
    Saneto, A
    Takezawa, H
    Mohri, N
    Miyake, H
    [J]. PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY, 2001, 25 (02): : 138 - 144
  • [5] FURUTANI K, 2006, P INT C ADV MAT PROC
  • [6] FURUTANI K, 2007, P 40 CIRP INT SEM MA
  • [7] Furutani K, 2004, INT J ELECT MACH, V9, P15
  • [8] ISHIKAWA K, 2003, J JPN SOC ABRASIVE T, V47, P495
  • [9] ISHIKAWA K, 1996, J JAPAN SOC PRECISIO, V62, P242
  • [10] Mohri N., 1993, CIRP Ann, V42, P219
12