Influence of Mn-Ni alloying elements on surface film and pitting resistance of Cr-Mn austenitic stainless steels

被引：14
|
作者：
Qu, H. P. [1 ]
Chen, H. T. [1 ]
Lang, Y. P. [1 ]
机构：
[1] CISRI, Inst Special Steels, 76 Haidiannan Rd, Beijing, Peoples R China
来源：
CONSTRUCTION AND BUILDING MATERIALS | 2016年 / 125卷
关键词：
Stainless steel; XPS; Argon sputter; Passive film; Pitting potential; PASSIVE FILM; CORROSION BEHAVIOR; HIGH-TEMPERATURE; XPS; CHLORIDE; AES; INCLUSIONS; MANGANESE;
D O I：
10.1016/j.conbuildmat.2016.08.059
中图分类号：
TU [建筑科学];
学科分类号：
0813 ;
摘要：
This research focused on surface film and corrosion resistance of three commercial type 200 austenitic stainless steels including L4, L1 and LH with different Mn/Ni mass ratio in Chinese market. X-ray photoelectron spectrum (XPS) results showed that Fe, Cr and Mn oxide layer thickness and passive film thickness were reduced as Mn/Ni mass ratio increased. Mn enrichment was only found in LH passive film. Mn oxide percentage in LH passive film was also the highest. These disadvantages deteriorated pitting resistance of LH, which was proved by anodic polarization result. Mn/Ni mass ratio should not be higher than 1.7 to ensure good corrosion resistance and low raw material cost. (C) 2016 Elsevier Ltd. All rights reserved.
引用
收藏
页码：427 / 437
页数：11
相关论文
共 50 条
  • [21] Strain-induced martensite formation and mechanical properties of a low-Ni N-containing Cr-Mn austenitic stainless steel
    Ansari, Farideh
    Mirzadeh, Hamed
    Dehghanian, Changiz
    JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 2025, 36 : 1504 - 1510
  • [22] Influence of chemical composition on the pitting corrosion resistance of non-standard low-Ni high-Mn-N duplex stainless steels
    Merello, R
    Botana, FJ
    Botella, J
    Matres, MV
    Marcos, M
    CORROSION SCIENCE, 2003, 45 (05) : 909 - 921
  • [23] Effect of halide anions and temperature on initiation of pitting in Cr-Mn-N and Cr-Ni steels
    Tzaneva, BR
    Fachikov, LB
    Raicheff, RG
    CORROSION ENGINEERING SCIENCE AND TECHNOLOGY, 2006, 41 (01) : 62 - 66
  • [24] Effects of Cr on pitting corrosion resistance and passive film properties of austenitic Fe-19Mn-12Al-1.5 C lightweight steel
    Ha, Heon-Young
    Kim, Kyeong-Won
    Park, Seong-Jun
    Lee, Tae-Ho
    Park, Hyungkwon
    Moon, Joonoh
    Hong, Hyun-Uk
    Lee, Chang-Hoon
    CORROSION SCIENCE, 2022, 206
  • [25] Correlation between pitting susceptibility and surface acidity, point of zero charge of passive film on aluminum: Influence of alloying elements
    Chen, Dihao
    Li, Menglin
    Yue, Xiaoqi
    Ji, Yucheng
    Xu, Yongtao
    Pan, Jinshan
    Dong, Chaofang
    CORROSION SCIENCE, 2024, 227
  • [26] Laser alloying with Mn+Cr3C2 and Mn + NiCr-C for improved wear and corrosion resistance of stainless steel
    Zhou, Rui
    Sun, Guifang
    SURFACE & COATINGS TECHNOLOGY, 2022, 451
  • [27] Synergy between molybdenum and nitrogen on the pitting corrosion and passive film resistance of austenitic stainless steels as a pH-dependent effect
    Loable, Carole
    Vicosa, Isadora N.
    Mesquita, Thiago J.
    Mantel, Marc
    Nogueira, Ricardo P.
    Berthome, Gregory
    Chauveau, Eric
    Roche, Virginie
    MATERIALS CHEMISTRY AND PHYSICS, 2017, 186 : 237 - 245
  • [28] Influence of Alloying Elements on Mechanical Properties and Corrosion Resistance of Cold Rolled C-Mn-Si TRIP Steels
    Zhang Ling-yun
    Wu Di
    Li Zhuang
    JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL, 2012, 19 (12) : 42 - 47
  • [29] XPS investigation of surface films on high Cr-Ni ferritic and austenitic stainless steels
    Lothongkum, G
    Chaikittisilp, S
    Lothongkum, AW
    APPLIED SURFACE SCIENCE, 2003, 218 (1-4) : 202 - 209
  • [30] The Influence of Cold Working on Semiconducting Properties of Passive Film and Pitting Corrosion Resistance of High Nitrogen Austenitic Stainless Steel
    Xu, LiWei
    Li, HuaBing
    Ma, QiFeng
    Jiang, ZhouHua
    Zhan, DongPing
    ADVANCED MATERIALS, PTS 1-3, 2012, 415-417 : 784 - +
12345