Optimization of heat treatment conditions of magnesium cast alloys

被引：18

作者：

Dobrzanski, L. A. ^{[1
]}

Tanski, T. ^{[1
]}

Trzaska, J. ^{[1
]}

机构：

[1] Silesian Tech Univ, Inst Engn Mat & Biomat, PL-44100 Gliwice, Poland

来源：

THERMEC 2009, PTS 1-4 | 2010年 / 638-642卷

关键词：

Magnesium alloys; Heat treatment; Mechanical properties; Neural network; NEURAL-NETWORKS;

D O I：

10.4028/www.scientific.net/MSF.638-642.1488

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

In this paper there are presented results of the optimization of heat treatment conditions, which are temperature and heating time during solution heat treatment or ageing as well the cooling rate after solution treatment for MCMgAl12Zn1, MCMgA19Zn1, MCMgA16Zn1, MCMgA13Zn1 cast magnesium alloys. A casting cycle of alloys has been carried out in an induction crucible furnace using a protective salt bath Flux 12 equipped with two ceramic filters at the melting temperature of 750 +/- 10 degrees C, suitable for the manufactured material. The heat treatment involve the solution heat treatment and cooling in different cooling mediums as well water, air and furnace The improvement of the manufacturing technique and chemical composition as well as of heat treatment and cooling methods leads to the development of a material designing process for the optimal physical and mechanical properties of a new developed alloy

引用

页码：1488 / 1493

页数：6

共 9 条

[1] Structure and properties of magnesium cast alloys [J].

Dobrzanski, L. A. ;

Tanski, T. ;

Cizek, L. ;

Brytan, Z. .

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2007, 192 :567-574

[2] Influence of aluminium content on behaviour of magnesium cast alloys in bentonite sand mould [J].

Silesian University of Technology, Division of Materials Processing Technology and Computer Techniques in Materials Science, Institute of Engineering Materials and Biomaterials, Konarskiego St. 18a, Gliwice ;

44-100, Poland .

Solid State Phenomena, 2009, (764-769)

[3]

FAJKIEL A, 2002, FOUNDRY ENG 21 C DIR

[4]

Kainer K.U., 2003, MAGNESIUM ALLOYS TEC

[5] Methodology for automatic control of automotive Al-Si cast components [J].

Krupinski, M. ;

Dobrzanski, L. A. ;

Sokolowski, J. H. ;

Kasprzak, W. ;

Byczynski, G. .

THERMEC 2006, PTS 1-5, 2007, 539-543 :339-+

[6] Feasibility of using neural networks for real-time prediction of the mechanical properties of finished rolled products [J].

Kurban, V. V. ;

Yatsenko, N. L. ;

Belyakova, V. I. .

METALLURGIST, 2007, 51 (1-2) :3-6

[7]

NECAT R, 2005, J MATER SCI, V40, P1767

[8]

Rzychon T., 2007, Journal of Achievements in Materials and Manufacturing Engineering, V21, P31

[9] Application of neural networks for designing the chemical composition of steel with the assumed hardness after cooling from the austenitising temperature [J].

Trzaska, J ;

Dobrzanski, LA .

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 2005, 164 :1637-1643

← 1 →