Heat transfer augmentation for air jet impinged on a rough surface

An experimental investigation of heat transfer from a round air jet impinging normally from below onto a heated square plate was performed. The objective of the investigation was to study the effect of roughness on both the heat transfer and the fluid how characteristics. Smooth and rough plates were, therefore, used in the course of the experiments. The heat transfer data were collected for four jet Reynolds numbers, ranging from 6500 to 19000. The Reynolds numbers are based on the jet-exit velocity (U-e) and the nozzle-exit diameter (D), Re-e = UeD/nu. The nozzle-to-plate distance ranged from 0.05 to 15 nozzle-exit diameter to cover both the potential core and the far regions of the jet flow. The roughness was composed of cubes of 1 mm dimension distributed uniformly along the plate. The local and average Nusselt number values for the rough plate showed an increase ranging from 8.9% to 28% over those for the smooth plate. Roughness was found to have a strong effect on the flow characteristics; it affected the mean velocity as well as the turbulence intensity of the how. The mean velocity profiles for the smooth case at radial distances of r/D = 1 and r/D = 2.5 showed steeper near-wall velocity gradients compared with the profiles of the rough case, where r is the radial distance measured from the plate center along the plate centerline. In addition, roughness caused an increase in the turbulence intensity of the flow. (C) 1998 Elsevier Science Ltd. All rights reserved.