Effect of heating temperature, pH, concentration and starch/whey protein ratio on the viscoelastic properties of corn starch/whey protein mixed gels

The viscoelastic properties of corn starch (CS) gels were more dependent on heating temperature, while the properties of whey protein isolate (WPI) gels were more dependent on pH. Thus heating temperature (75, 55, 95 degreesC) and pH (5, 7, 9) were varied to obtain a series of mixed gels with interesting viscoelastic properties. WPI gels showed extensive stress relaxation (SR) indicative of a highly transient network structure, while GS gels relaxed very little in 2000 s. Base on SR results, it appeared that CS/WPI mixed gels with 25 and 50% CS formed compatible network structures at 15% total solids only at pH 9. This supposition was supported by SEM microstructures obtained for dehydrated gels and a synergistic increase in the large-strain fracture stress for these gels. Some synergy was also found for mixed gels at 30% total solids at pH 9, while at pH 7 the mixed gels seemed to contain separate additive WPI and CS networks unlike the case for pH 7 at 15% total solids. In both cases (15 and 30% total solids) the degree of elasticity of the mixed gels decreased as the WPI content increased. Mixed gels (CS:WPI=0.5) at pH 9 showed increased fracture stress and fracture strain relative to the same gels at pH 7. This suggests that a unique chemical compatibility exists at pH 9 and results in gels that combine the elasticity of CS and the interval stress dissipation of WPI. (C) 2001 Society of Chemical industry.