Mold materials for permanent molding of aluminum alloys
被引:0
作者:
Wallace, JF
论文数: 0引用数: 0
h-index: 0
机构:
Case Western Reserve Univ, Cleveland, OH 44106 USACase Western Reserve Univ, Cleveland, OH 44106 USA
Wallace, JF
[1
]
Schwam, D
论文数: 0引用数: 0
h-index: 0
机构:
Case Western Reserve Univ, Cleveland, OH 44106 USACase Western Reserve Univ, Cleveland, OH 44106 USA
Schwam, D
[1
]
机构:
[1] Case Western Reserve Univ, Cleveland, OH 44106 USA
来源:
TRANSACTIONS OF THE AMERICAN FOUNDRYMEN'S SOCIETY, VOL 107
|
1999年
/
107卷
关键词:
D O I:
暂无
中图分类号:
TF [冶金工业];
学科分类号:
0806 ;
摘要:
A test that determines the relative thermal fatigue resistance of mold materials for permanent mold aluminum alloys has been developed. This test has been used to test the thermal fatigue resistance of seller al potential mold materials. The results indicate that a relatively lower thermal fatigue resistance is obtained with gray irons. The resistance of compacted graphite and ductile irons was next, followed by the cast 4140 and H-13 die steel, with the best resistances from properly heat treated wrought PG H-13 steel. The higher hardness materials generally produce better thermal fatigue resistance.