Grain refinement vs. crystallographic texture: Mechanical anisotropy in a magnesium alloy

被引：91
作者：
Foley, D. C. [1 ]
Al-Maharbi, M. [1 ]
Hartwig, K. T. [1 ,2 ]
Karaman, I. [1 ,2 ]
Kecskes, L. J. [3 ]
Mathaudhu, S. N. [3 ]
机构：
[1] Texas A&M Univ, Mat Sci & Engn Program, College Stn, TX 77843 USA
[2] Texas A&M Univ, Dept Mech Engn, College Stn, TX 77843 USA
[3] USA, Res Lab, Weap & Mat Res Directorate, Aberdeen Proving Ground, Aberdeen Proving Ground, MD 21005 USA
来源：
SCRIPTA MATERIALIA | 2011年 / 64卷 / 02期
关键词：
Equal channel angular extrusion/pressing; Magnesium alloys; Ultrafine-grained materials; Anisotropy; Crystallographic texture; CHANNEL ANGULAR EXTRUSION; SEVERE PLASTIC-DEFORMATION; ZN ALLOY; EVOLUTION; STRENGTH; MICROSTRUCTURE; DUCTILITY; AZ31B; TWINS; ECAE;
D O I：
10.1016/j.scriptamat.2010.09.042
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
A magnesium alloy was subjected to severe plastic deformation via an unconventional equal channel angular extrusion route at decreasing temperatures. This method facilitates incremental grain refinement and enhances formability by activating dynamic recrystallization in the initial steps and suppressing deformation twinning. Compression experiments in three orthogonal directions demonstrated high strength levels in the processed sample, up to 350 MPa in yield and 500 MPa in ultimate strengths. Notable flow stress anisotropy is correlated with the processing texture and microstructure. (C) 2010 Published by Elsevier Ltd. on behalf of Acta Materialia Inc.
引用
收藏
页码：193 / 196
页数：4
相关论文
共 22 条
[21]   Dynamic continuous recrystallization characteristics in two stage deformation of Mg-3A1-lZn alloy sheet [J].
Tan, JC ;
Tan, MJ .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 339 (1-2) :124-132
[22]   Improving the mechanical properties of magnesium and a magnesium alloy through severe plastic deformation [J].
Yamashita, A ;
Horita, Z ;
Langdon, TG .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2001, 300 (1-2) :142-147
123