Influence of high power impulse magnetron sputtering plasma ionization on the microstructure of TiN thin films

被引:109
|
作者
Ehiasarian, A. P. [1 ]
Vetushka, A. [1 ]
Gonzalvo, Y. Aranda [2 ]
Safran, G. [3 ]
Szekely, L. [3 ]
Barna, P. B. [3 ]
机构
[1] Sheffield Hallam Univ, Nanotechnol Ctr PVD Res, Mat & Engn Inst, Howard St, Sheffield S1 1WB, S Yorkshire, England
[2] Hiden Analyt Ltd, Plasma & Surface Div, Warrington WA5 7UN, Cheshire, England
[3] Res Inst Tech Phys & Mat Sci, H-1525 Budapest, Hungary
基金
英国工程与自然科学研究理事会;
关键词
PREFERRED ORIENTATION; ENERGY-DISTRIBUTION; SURFACE-MORPHOLOGY; STRESS GENERATION; GROWTH; OXYGEN; LAYERS; DEPOSITION; DENSITIES; TIN(111);
D O I
10.1063/1.3579443
中图分类号
O59 [应用物理学];
学科分类号
摘要
HIPIMS (High Power Impulse Magnetron Sputtering) discharge is a new PVD technology for the deposition of high-quality thin films. The deposition flux contains a high degree of metal ionization and nitrogen dissociation. The microstructure of HIPIMS-deposited nitride films is denser compared to conventional sputter technologies. However, the mechanisms acting on the microstructure, texture and properties have not been discussed in detail so far. In this study, the growth of TIN by HIPIMS of Ti in mixed Ar and N-2 atmosphere has been investigated. Varying degrees of metal ionization and nitrogen dissociation were produced by increasing the peak discharge current (I-d) from 5 to 30 A. The average power was maintained constant by adjusting the frequency. Mass spectrometry measurements of the deposition flux revealed a high content of ionized film-forming species, such as Ti1+, Ti2+ and atomic nitrogen N1+. Ti1+ ions with energies up to 50 eV were detected during the pulse with reducing energy in the pulse-off times. Langmuir probe measurements showed that the peak plasma density during the pulse was 3 x 10(16) m(-3). Plasma density, and ion flux ratios of N1+ : N-2(1+) and Ti1+:Ti-0 increased linearly with peak current. The ratios exceeded 1 at 30 A. TIN films deposited by HIRIMS were analyzed by X-ray diffraction, and transmission electron microscopy. At high I-d, N1+:N-2(1+) > 1 and Ti1+:Ti-0 > 1 were produced; a strong 002 texture was present and column boundaries in the films were atomically tight. As I-d reduced and N1+: N-2(1+) and Ti1+:Ti-0 dropped below 1, the film texture switched to strong 111 with a dense structure. At very low I-d, porosity between columns developed. The effects of the significant activation of the deposition flux observed in the HIPIMS discharge on the film texture, microstructure, morphology and properties are discussed. (C) 2011 American Institute of Physics. [doi :10.1063/1.3579443]
引用
收藏
页数:15
相关论文
共 50 条
  • [41] Control of aluminum doping of ZnO:Al thin films obtained by high-power impulse magnetron sputtering
    Tiron, V.
    Sirghi, L.
    Popa, G.
    THIN SOLID FILMS, 2012, 520 (13) : 4305 - 4309
  • [42] TiN Films Deposited on Uranium by High Power Pulsed Magnetron Sputtering under Low Temperature
    Ding, Jingjing
    Yin, Xixi
    Fang, Liping
    Meng, Xiandong
    Yin, Anyi
    MATERIALS, 2018, 11 (08)
  • [43] Influence of reactive oxygen species during deposition of iron oxide films by high power impulse magnetron sputtering
    Stranak, V.
    Hubicka, Z.
    Cada, M.
    Bogdanowicz, R.
    Wulff, H.
    Helm, C. A.
    Hippler, R.
    JOURNAL OF PHYSICS D-APPLIED PHYSICS, 2018, 51 (09)
  • [44] Discharge physics of high power impulse magnetron sputtering
    Anders, Andre
    SURFACE & COATINGS TECHNOLOGY, 2011, 205 : S1 - S9
  • [45] Fractal Characteristics and Microstructure Evolution of Magnetron Sputtering Cu Thin Films
    Du Shiwen
    Li Yongtang
    CHINESE JOURNAL OF MECHANICAL ENGINEERING, 2013, 26 (01) : 137 - 143
  • [46] Metal filling by high power impulse magnetron sputtering
    Jablonka, Lukas
    Moskovkin, Pavel
    Zhang, Zhen
    Zhang, Shi-Li
    Lucas, Stephane
    Kubart, Tomas
    JOURNAL OF PHYSICS D-APPLIED PHYSICS, 2019, 52 (36)
  • [47] Synthesis of hydrogenated diamondlike carbon thin films using neon-acetylene based high power impulse magnetron sputtering discharges
    Aijaz, Asim
    Louring, Sascha
    Lundin, Daniel
    Kubart, Tomas
    Jensen, Jens
    Sarakinos, Kostas
    Helmersson, Ulf
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2016, 34 (06):
  • [48] High power impulse magnetron sputtering using a rotating cylindrical magnetron
    Leroy, W. P.
    Mahieu, S.
    Depla, D.
    Ehiasarian, A. P.
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2010, 28 (01): : 108 - 111
  • [49] Epitaxial growth of TiZrNbTaN films without external heating by high-power impulse magnetron sputtering
    Honnali, Sanath Kumar
    Boyd, Robert
    Magnusson, Roger
    le Febvrier, Arnaud
    Lundin, Daniel
    Greczynski, Grzegorz
    Eklund, Per
    SURFACE & COATINGS TECHNOLOGY, 2025, 495
  • [50] Influence of discharge power and annealing temperature on the properties of indium tin oxide thin films prepared by pulsed-DC magnetron sputtering
    Huang, Mei
    Hameiri, Ziv
    Aberle, Armin G.
    Mueller, Thomas
    VACUUM, 2015, 121 : 187 - 193