Influence of high power impulse magnetron sputtering plasma ionization on the microstructure of TiN thin films

被引:109
|
作者
Ehiasarian, A. P. [1 ]
Vetushka, A. [1 ]
Gonzalvo, Y. Aranda [2 ]
Safran, G. [3 ]
Szekely, L. [3 ]
Barna, P. B. [3 ]
机构
[1] Sheffield Hallam Univ, Nanotechnol Ctr PVD Res, Mat & Engn Inst, Howard St, Sheffield S1 1WB, S Yorkshire, England
[2] Hiden Analyt Ltd, Plasma & Surface Div, Warrington WA5 7UN, Cheshire, England
[3] Res Inst Tech Phys & Mat Sci, H-1525 Budapest, Hungary
基金
英国工程与自然科学研究理事会;
关键词
PREFERRED ORIENTATION; ENERGY-DISTRIBUTION; SURFACE-MORPHOLOGY; STRESS GENERATION; GROWTH; OXYGEN; LAYERS; DEPOSITION; DENSITIES; TIN(111);
D O I
10.1063/1.3579443
中图分类号
O59 [应用物理学];
学科分类号
摘要
HIPIMS (High Power Impulse Magnetron Sputtering) discharge is a new PVD technology for the deposition of high-quality thin films. The deposition flux contains a high degree of metal ionization and nitrogen dissociation. The microstructure of HIPIMS-deposited nitride films is denser compared to conventional sputter technologies. However, the mechanisms acting on the microstructure, texture and properties have not been discussed in detail so far. In this study, the growth of TIN by HIPIMS of Ti in mixed Ar and N-2 atmosphere has been investigated. Varying degrees of metal ionization and nitrogen dissociation were produced by increasing the peak discharge current (I-d) from 5 to 30 A. The average power was maintained constant by adjusting the frequency. Mass spectrometry measurements of the deposition flux revealed a high content of ionized film-forming species, such as Ti1+, Ti2+ and atomic nitrogen N1+. Ti1+ ions with energies up to 50 eV were detected during the pulse with reducing energy in the pulse-off times. Langmuir probe measurements showed that the peak plasma density during the pulse was 3 x 10(16) m(-3). Plasma density, and ion flux ratios of N1+ : N-2(1+) and Ti1+:Ti-0 increased linearly with peak current. The ratios exceeded 1 at 30 A. TIN films deposited by HIRIMS were analyzed by X-ray diffraction, and transmission electron microscopy. At high I-d, N1+:N-2(1+) > 1 and Ti1+:Ti-0 > 1 were produced; a strong 002 texture was present and column boundaries in the films were atomically tight. As I-d reduced and N1+: N-2(1+) and Ti1+:Ti-0 dropped below 1, the film texture switched to strong 111 with a dense structure. At very low I-d, porosity between columns developed. The effects of the significant activation of the deposition flux observed in the HIPIMS discharge on the film texture, microstructure, morphology and properties are discussed. (C) 2011 American Institute of Physics. [doi :10.1063/1.3579443]
引用
收藏
页数:15
相关论文
共 50 条
  • [31] Graphite-like carbon films by high power impulse magnetron sputtering
    Huang, Meidong
    Zhang, Xueqian
    Ke, Peiling
    Wang, Aiying
    APPLIED SURFACE SCIENCE, 2013, 283 : 321 - 326
  • [32] Enhanced properties of tungsten films by high-power impulse magnetron sputtering
    Engwall, A. M.
    Shin, S. J.
    Bae, J.
    Wang, Y. M.
    SURFACE & COATINGS TECHNOLOGY, 2019, 363 : 191 - 197
  • [33] ZrB2 thin films grown by high power impulse magnetron sputtering from a compound target
    Samuelsson, Mattias
    Jensen, Jens
    Helmersson, Ulf
    Hultman, Lars
    Hogberg, Hans
    THIN SOLID FILMS, 2012, 526 : 163 - 167
  • [34] Controlling the B/Ti ratio of TiBx thin films grown by high-power impulse magnetron sputtering
    Bakhit, Babak
    Petrov, Ivan
    Greene, J. E.
    Hultman, Lars
    Rosen, Johanna
    Greczynski, Grzegorz
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2018, 36 (03):
  • [35] Synthesis and Characterization of Boron Nitride Thin Films Deposited by High-Power Impulse Reactive Magnetron Sputtering
    Stankus, Vytautas
    Vasiliauskas, Andrius
    Guobiene, Asta
    Andrulevicius, Mindaugas
    Meskinis, Sarunas
    MOLECULES, 2024, 29 (22):
  • [36] Effects of Cathode Voltage Pulse Width in High Power Impulse Magnetron Sputtering on the Deposited Chromium Thin Films
    Kuo, Chin-Chiuan
    Lin, Chun-Hui
    Lin, Yu-Tse
    Chang, Jing-Tang
    COATINGS, 2020, 10 (06)
  • [37] p-type cuprous oxide thin films with high conductivity deposited by high power impulse magnetron sputtering
    Sun, Hui
    Chen, Sheng-Chi
    Wen, Chao-Kuang
    Chuang, Tung-Han
    Yazdi, Mohammad Arab Pour
    Sanchette, Frederic
    Billard, Alain
    CERAMICS INTERNATIONAL, 2017, 43 (08) : 6214 - 6220
  • [38] Research Review of the Plasma with Spoke Characteristic for High Power Impulse Magnetron Sputtering
    Li Yuge
    Liu Weiyang
    Lei Mingkai
    CHINA SURFACE ENGINEERING, 2022, 35 (01) : 1 - 9
  • [39] Influence of high power impulse magnetron sputtering pulse parameters on the properties of aluminum nitride coatings
    Yang, Yung-Chin
    Chang, Chen-Te
    Hsiao, Yu-Chiao
    Lee, Jyh-Wei
    Lou, Bih-Show
    SURFACE & COATINGS TECHNOLOGY, 2014, 259 : 219 - 231
  • [40] High power impulse magnetron sputtering (HiPIMS) for the fabrication of antimicrobial and transparent TiO2 thin films
    Lou, Bih-Show
    Chen, Wei-Ting
    Diyatmika, Wahyu
    Lu, Jong-Hong
    Chang, Chen-Te
    Chen, Po-Wen
    Lee, Jyh-Wei
    CURRENT OPINION IN CHEMICAL ENGINEERING, 2022, 36