Influence of high power impulse magnetron sputtering plasma ionization on the microstructure of TiN thin films

被引:115
作者
Ehiasarian, A. P. [1 ]
Vetushka, A. [1 ]
Gonzalvo, Y. Aranda [2 ]
Safran, G. [3 ]
Szekely, L. [3 ]
Barna, P. B. [3 ]
机构
[1] Sheffield Hallam Univ, Nanotechnol Ctr PVD Res, Mat & Engn Inst, Howard St, Sheffield S1 1WB, S Yorkshire, England
[2] Hiden Analyt Ltd, Plasma & Surface Div, Warrington WA5 7UN, Cheshire, England
[3] Res Inst Tech Phys & Mat Sci, H-1525 Budapest, Hungary
基金
英国工程与自然科学研究理事会;
关键词
PREFERRED ORIENTATION; ENERGY-DISTRIBUTION; SURFACE-MORPHOLOGY; STRESS GENERATION; GROWTH; OXYGEN; LAYERS; DEPOSITION; DENSITIES; TIN(111);
D O I
10.1063/1.3579443
中图分类号
O59 [应用物理学];
学科分类号
摘要
HIPIMS (High Power Impulse Magnetron Sputtering) discharge is a new PVD technology for the deposition of high-quality thin films. The deposition flux contains a high degree of metal ionization and nitrogen dissociation. The microstructure of HIPIMS-deposited nitride films is denser compared to conventional sputter technologies. However, the mechanisms acting on the microstructure, texture and properties have not been discussed in detail so far. In this study, the growth of TIN by HIPIMS of Ti in mixed Ar and N-2 atmosphere has been investigated. Varying degrees of metal ionization and nitrogen dissociation were produced by increasing the peak discharge current (I-d) from 5 to 30 A. The average power was maintained constant by adjusting the frequency. Mass spectrometry measurements of the deposition flux revealed a high content of ionized film-forming species, such as Ti1+, Ti2+ and atomic nitrogen N1+. Ti1+ ions with energies up to 50 eV were detected during the pulse with reducing energy in the pulse-off times. Langmuir probe measurements showed that the peak plasma density during the pulse was 3 x 10(16) m(-3). Plasma density, and ion flux ratios of N1+ : N-2(1+) and Ti1+:Ti-0 increased linearly with peak current. The ratios exceeded 1 at 30 A. TIN films deposited by HIRIMS were analyzed by X-ray diffraction, and transmission electron microscopy. At high I-d, N1+:N-2(1+) > 1 and Ti1+:Ti-0 > 1 were produced; a strong 002 texture was present and column boundaries in the films were atomically tight. As I-d reduced and N1+: N-2(1+) and Ti1+:Ti-0 dropped below 1, the film texture switched to strong 111 with a dense structure. At very low I-d, porosity between columns developed. The effects of the significant activation of the deposition flux observed in the HIPIMS discharge on the film texture, microstructure, morphology and properties are discussed. (C) 2011 American Institute of Physics. [doi :10.1063/1.3579443]
引用
收藏
页数:15
相关论文
共 47 条
[1]   Low-energy ion irradiation during film growth:: Kinetic pathways leading to enhanced adatom migration rates -: art. no. 211915 [J].
Adamovic, D ;
Münger, EP ;
Chirita, V ;
Hultman, L ;
Greene, JE .
APPLIED PHYSICS LETTERS, 2005, 86 (21) :1-3
[2]   On the relationship between the peak target current and the morphology of chromium nitride thin films deposited by reactive high power pulsed magnetron sputtering [J].
Alami, J. ;
Sarakinos, K. ;
Uslu, F. ;
Wuttig, M. .
JOURNAL OF PHYSICS D-APPLIED PHYSICS, 2009, 42 (01)
[3]   High power impulse magnetron sputtering: Current-voltage-time characteristics indicate the onset of sustained self-sputtering [J].
Anders, Andre ;
Andersson, Joakim ;
Ehiasarian, Arutiun .
JOURNAL OF APPLIED PHYSICS, 2007, 102 (11)
[4]   Self-sputtering runaway in high power impulse magnetron sputtering: The role of secondary electrons and multiply charged metal ions [J].
Anders, Andre .
APPLIED PHYSICS LETTERS, 2008, 92 (20)
[5]   Observation of Ti4+ ions in a high power impulse magnetron sputtering plasma [J].
Andersson, Joakim ;
Ehiasarian, Arutiun P. ;
Anders, Andre .
APPLIED PHYSICS LETTERS, 2008, 93 (07)
[6]   Amorphisation and surface morphology development at low-energy ion milling [J].
Barna, A ;
Pécz, B ;
Menyhard, M .
ULTRAMICROSCOPY, 1998, 70 (03) :161-171
[7]   FORMATION OF ALUMINUM THIN-FILMS IN THE PRESENCE OF OXYGEN AND NICKEL [J].
BARNA, A ;
BARNA, PB ;
RADNOCZI, G ;
REICHA, FM ;
TOTH, L .
PHYSICA STATUS SOLIDI A-APPLIED RESEARCH, 1979, 55 (02) :427-435
[8]   Fundamental structure forming phenomena of polycrystalline films and the structure zone models [J].
Barna, PB ;
Adamik, M .
THIN SOLID FILMS, 1998, 317 (1-2) :27-33
[9]   SURFACE GROWTH TOPOGRAPHY OF GRAIN-BOUNDARIES IN AL THIN-FILMS [J].
BARNA, PB ;
RADNOCZI, G ;
REICHA, FM .
VACUUM, 1988, 38 (07) :527-532
[10]   Multiscale modeling of thin-film deposition: Applications to Si device processing [J].
Baumann, FH ;
Chopp, DL ;
de la Rubia, TD ;
Gilmer, GH ;
Greene, JE ;
Huang, H ;
Kodambaka, S ;
O'Sullivan, P ;
Petrov, I .
MRS BULLETIN, 2001, 26 (03) :182-189