MEASUREMENT OF THE DISC-PAD FRICTION COEFFICIENT FOR MECHANICAL BRAKES USING DIRECT AND INDIRECT METHODS

It is necessary to guarantee the proper brake force to stop a train safely in a limited distance and o adjust its speed. Currently, most trains are run by electrical power and have a combined electrical and mechanical (friction) braking system. The mechanical brake force is determined by many parameters, such as the friction coefficient of the brake disc and pad, the pressure in the brake cylinder, the brake cylinder's cross sectional area and the brake linkage ratio. In general, the friction coefficient data of the brake disc and pad have been taken through a dynamo-test in a laboratory, but these data might not be well matched with real data under operating conditions because of the difference in data acquisition conditions. The present study examined two methodologies that can measure the friction coefficient of the brake pad and disc based on a train's real operating conditions. The first method was the direct method, which measured the brake force and clamping force applied on the mechanical brake by using strain gauges installed on the brake to calculate the friction coefficient. The second was an indirect method that obtained the friction coefficient by using the weight of the train and the equivalent brake force. Those variables were calculated from the longitudinal dynamic characteristics, such as resistance to motion, gradient resistance and curved resistance. These two methodologies were used to obtain the disc-pad friction coefficient for the mechanical brakes of a Korean high-speed train (HSR350x).