A study of indium tin oxide thin film deposited at low temperature using facing target sputtering system

Indium tin oxide (ITO) thin films, for electroluminescent display electrodes, must be of low resistivity and high transparency. In this study, a facing target sputtering system was used to fabricate this film in order to improve its electrical and optical properties. Temperature was one of the most critical factors during fabrication. Scanning electron microscopy (SEM) and X-ray diffraction XRD were used to analyze the surface morphology and structure of ITO thin films. It was concluded that the ITO films deposited between 50 and 200 degreesC were polycrystalline. Under 50 degreesC, the ITO films were amorphous or had mixed amorphous and crystalline phases. After post-annealing, the amorphous ITO films could become crystalline, and therefore, the electrical property of amorphous ITO films could be effectively improved. In this research, an ITO film with the resistivity as low as 1.99 X 10(-4) Ohm cm and transparency above 85% within the visible wavelengths 400 similar to 800 nm, was obtained after vacuum annealing at 300 degreesC for 2 h, while deposited at a working pressure 0.1333 Pa, percentage oxygen flow rate 22.7% in Ar+O-2 gas mixture, substrate temperature 75 degreesC, and input DC power 50 W for 30 min. The corresponding deposition rate for this film was 22 nm/min. (C) 2002 Elsevier Science B.V All rights reserved.