The feasibility of laminar screw placement in the subaxial spine: analysis using 215 three-dimensional computed tomography scans and simulation software

被引:18
作者
Shin, Sang Ik [4 ,5 ]
Yeom, Jin S. [1 ,2 ,3 ]
Kim, Ho-Joong [1 ,2 ,3 ]
Chang, Bong-Soon [4 ,5 ]
Lee, Choon-Ki [4 ,5 ]
Riew, K. Daniel [6 ]
机构
[1] Seoul Natl Univ, Coll Med, Spine Ctr, Songnam 463707, South Korea
[2] Seoul Natl Univ, Coll Med, Dept Orthopaed Surg, Songnam 463707, South Korea
[3] Seoul Natl Univ, Bundang Hosp, Songnam 463707, South Korea
[4] Seoul Natl Univ, Coll Med, Dept Orthopaed Surg, Seoul 110744, South Korea
[5] Seoul Natl Univ Hosp, Seoul 110744, South Korea
[6] Washington Univ, Dept Orthopaed Surg, St Louis, MO 63110 USA
关键词
Laminar screw; Subaxial spine; Lower cervical spine; Feasibility; Screw trajectory; LATERAL MASS SCREWS; CERVICAL-SPINE; BIOMECHANICAL ANALYSIS; ANATOMIC SUITABILITY; TECHNICAL NOTE; FIXATION; C2; COMPLICATIONS; INTRALAMINAR; INSERTION;
D O I
10.1016/j.spinee.2012.07.010
中图分类号
R74 [神经病学与精神病学];
学科分类号
摘要
BACKGROUND CONTEXT: There have been several reports describing the usage of subaxial cervical laminar screws. However, the anatomic feasibility of placing such screws has not been thoroughly evaluated yet. PURPOSE: To determine the feasibility of the laminar screw placement in the subaxial cervical spine using a large number of computed tomography (CT) scans and three-dimensional screw trajectory software. STUDY DESIGN: Three-dimensional simulation study of screw placement. PATIENT SAMPLE: Computed tomography scans of 215 consecutive patients were examined, for a total of 430 screws at each level of the subaxial cervical spine. OUTCOME MEASURES: Successful screw placement without laminar cortical breach, facet joint violation, and collision between two screws in the same level. METHODS: We simulated the placement of 4.0-mm subaxial (C3-C7) cervical laminar screws. Unilateral and bilateral screw placement was simulated, and their success rates were evaluated at each level of the subaxial cervical spine. This study was not supported by any financial sources. One of the authors received royalties for a posterior cervical fixation system, which is not the topic of this article and is not used or mentioned in this article. RESULTS: The success rate of unilateral screw placement was the highest at C7 (91.4%), followed by C6 (31.9%), C3 (30.2%), C4 (6.3%), and C5 (4.0%). It was significantly higher (p<. 001) in men than in women at C6 and C7 but not at the other levels. The success rate of bilateral screw placement was the highest at C7 (68.8%), followed by C3 (13.5%), C6 (8.8%), C4 (1.9%), and C5 (0.9%). It was significantly higher in men (83.5%) than in women (52.0%) at C7 (p<. 001) but not at the other levels. CONCLUSIONS: The relatively high success rate at C7, particularly of unilateral placement, suggests that laminar screw placement can be a sound alternative method for fixation at this level. However, careful preoperative CT scan evaluation and patient selection are required, particularly for bilateral fixation in women. At C3 and C6, unilateral screw placement can be considered in approximately 30% of patients after careful selection using preoperative CT scans. At C4 and C5, neither unilateral nor bilateral screw fixation is recommended for most patients. (C) 2012 Elsevier Inc. All rights reserved.
引用
收藏
页码:577 / 584
页数:8
相关论文
共 27 条
  • [1] Complications of pedicle screw fixation in reconstructive surgery of the cervical spine
    Abumi, K
    Shono, Y
    Ito, M
    Taneichi, H
    Kotani, Y
    Kaneda, K
    [J]. SPINE, 2000, 25 (08) : 962 - 969
  • [2] The anatomic suitability of the C2 vertebra for intralaminar and pedicular fixation: a computed tomography study
    Bhatnagar, Rishi
    Yu, Warren D.
    Bergin, Patrick F.
    Matteini, Lauren E.
    O'Brien, Joseph R.
    [J]. SPINE JOURNAL, 2010, 10 (10) : 896 - 899
  • [3] Effect of frameless stereotaxy on the accuracy of C1-2 transarticular screw placement
    Bloch, O
    Holly, LT
    Park, J
    Obasi, C
    Kim, K
    Johnson, JP
    [J]. JOURNAL OF NEUROSURGERY, 2001, 95 (01) : 74 - 79
  • [4] Using lamina screws as a salvage technique at C-7: computed tomography and biomechanical analysis using cadaveric vertebrae Laboratory investigation
    Cardoso, Mario J.
    Dmitriev, Anton E.
    Helgeson, Melvin D.
    Stephens, Frederick
    Campbell, Victoria
    Lehman, Ronald A.
    Cooper, Patrick
    Rosner, Michael K.
    [J]. JOURNAL OF NEUROSURGERY-SPINE, 2009, 11 (01) : 28 - 33
  • [5] Anatomic considerations for the placement of C2 laminar screws
    Cassinelli, Ezequiel H.
    Lee, Michael
    Skalak, Anthony
    Ahn, Nicholas U.
    Wright, Neill M.
    [J]. SPINE, 2006, 31 (24) : 2767 - 2771
  • [6] Flexion failure of posterior cervical lateral mass screws - Influence of insertion technique and position
    Choueka, J
    Spivak, JM
    Kummer, FJ
    Steger, T
    [J]. SPINE, 1996, 21 (04) : 462 - 468
  • [7] POSTERIOR PLATES IN THE MANAGEMENT OF CERVICAL INSTABILITY - LONG-TERM RESULTS IN 44 PATIENTS
    FEHLINGS, MG
    COOPER, PR
    ERRICO, TJ
    [J]. JOURNAL OF NEUROSURGERY, 1994, 81 (03) : 341 - 349
  • [8] COMPLICATIONS OF POSTERIOR CERVICAL PLATING
    HELLER, JG
    SILCOX, DH
    SUTTERLIN, CE
    [J]. SPINE, 1995, 20 (22) : 2442 - 2448
  • [9] Significance of laminar screw fixation in the subaxial cervical spine
    Hong, Jae Taek
    Sung, Jae Hoon
    Son, Byung Chul
    Lee, Sang Won
    Park, Chun Kun
    [J]. SPINE, 2008, 33 (16) : 1739 - 1743
  • [10] Biomechanical Comparison of Three Different Types of C7 Fixation Techniques Lateral Mass Screw, Transpedicular Screw, and Intralaminar Screw
    Hong, Jae Taek
    Tomoyuki, Takigawa
    Udayakumar, Ranjith
    Orias, Alejandro A. Espinoza
    Inoue, Nozomu
    An, Howard S.
    [J]. SPINE, 2011, 36 (05) : 393 - 398