Atomic Layer Deposited TiO2 and Al2O3 Thin Films as Coatings for Aluminum Food Packaging Application

被引:35
作者
Dias, Vanessa [1 ,2 ]
Maciel, Homero [1 ,3 ]
Fraga, Mariana [4 ]
Lobo, Anderson O. [5 ]
Pessoa, Rodrigo [1 ,3 ]
Marciano, Fernanda R. [2 ,3 ]
机构
[1] Ctr Ciencia & Tecnol Plasmas & Mat PlasMat, ITA, BR-12228900 Sao Jose Dos Campos, SP, Brazil
[2] Univ Vale Paraiba Univap, Lab Nanotecnol Biomed, BR-12244000 Sao Jose Dos Campos, SP, Brazil
[3] Univ Brasil, Inst Cient & Tecnol, BR-08230030 Sao Paulo, SP, Brazil
[4] Univ Fed Sao Paulo Unifesp, Inst Cient & Tecnol, BR-12231280 Sao Jose Dos Campos, SP, Brazil
[5] Univ Fed Piaui UFPI, LIMAV Lab Interdisciplinar Mat Avancados, BR-64049550 Teresina, PI, Brazil
基金
巴西圣保罗研究基金会;
关键词
corrosion barrier; titanium dioxide; aluminum oxide; atomic layer deposition; linear sweep voltammetry; electrochemical impedance spectroscopy; CORROSION PROTECTION; BARRIER COATINGS; STAINLESS-STEEL; RESISTANCE; OXIDE; TEMPERATURE; ANTICORROSION; BEHAVIOR; COPPER; WATER;
D O I
10.3390/ma12040682
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
Titanium dioxide (TiO2) and aluminum oxide (Al2O3) coatings have been investigated in a wide range of bio-applications due to their biodegradation and biocompatibility properties, that are key parameters for their use in the food packaging and biomedical devices fields. The present study evaluates and compares the electrochemical behavior of the non-coated, commercial resin-coated, TiO2-coated and Al2O3-coated aluminum in commercial beer electrolyte. For this, TiO2 and Al2O3 thin films were deposited on aluminum (Al) substrates using atomic layer deposition (ALD). The evaluation of the corrosion barrier layer properties was performed by linear sweep voltammetry (LSV) during 10 min and electrochemical impedance spectroscopy (EIS). In addition, profilometry, grazing incidence X-ray diffractometry (GIXRD), scanning electron microscopy (SEM) and Fourier-transform infrared spectroscopy (FT-IR) analyses were performed to investigate the physical and chemical properties of the pristine and / or corroded samples. TiO2 and Al2O3 films presented an amorphous structure, a morphology that follows Al substrate surface, and a thickness of around 100 nm. Analysis of LSV data showed that ALD coatings promoted a considerable increase in corrosion barrier efficiency being 86.3% for TiO2-coated Al and 80% for Al2O3-coated Al in comparison with 7.1% of commercial resin-coated Al. This is mainly due to the lower electrochemical porosity, 11.4% for TiO2-coated Al and 20.4% for Al2O3-coated Al in comparison with 96% of the resin-coated Al, i.e. an increase of up to twofold in the protection of Al when coated with TiO2 compared to Al2O3. The EIS results allow us to complement the discussions about the reduced corrosion barrier efficiency of the Al2O3 film for beer electrolyte once SEM and FT-IR analyzes did not show drastic changes in both investigated ALD films after the corrosion assays. The above results indicate that ALD TiO2 and Al2O3 films may be a viable alternative to replace the synthetic resin coatings frequently used in aluminum cans of use in the food industry.
引用
收藏
页数:15
相关论文
共 45 条
  • [11] ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY OF COATED ALUMINUM BEVERAGE CONTAINERS .1. DETERMINATION OF AN OPTIMAL PARAMETER FOR LARGE-SAMPLE EVALUATION
    GRANDLE, JA
    TAYLOR, SR
    [J]. CORROSION, 1994, 50 (10) : 792 - 803
  • [12] Thin Al2O3 barrier coatings onto temperature-sensitive packaging materials by atomic layer deposition
    Hirvikorpi, Terhi
    Vaha-Nissi, Mika
    Nikkola, Juha
    Harlin, Ali
    Karppinen, Maarit
    [J]. SURFACE & COATINGS TECHNOLOGY, 2011, 205 (21-22) : 5088 - 5092
  • [13] Atomic layer deposited aluminum oxide barrier coatings for packaging materials
    Hirvikorpi, Terhi
    Vaha-Nissi, Mika
    Mustonen, Tuomas
    Iiskola, Eero
    Karppinen, Maarit
    [J]. THIN SOLID FILMS, 2010, 518 (10) : 2654 - 2658
  • [14] Jadav S., 2014, IJRET, V3, P43
  • [15] Electrochemical behavior of diamond-like carbon films for biomedical applications
    Kim, HG
    Ahn, SH
    Kim, JG
    Park, SJ
    Lee, KR
    [J]. THIN SOLID FILMS, 2005, 475 (1-2) : 291 - 297
  • [16] Koli D.K., 2014, PROCEDIA MAT SCI, V6, P567, DOI [10.1016/j.mspro.2014.07.072, DOI 10.1016/J.MSPRO.2014.07.072]
  • [17] LaKind Judy S., 2013, International Journal of Technology, Policy and Management, V13, P80
  • [18] Aluminium foil as a food packaging material in comparison with other materials
    Lamberti, Manuela
    Escher, Felix
    [J]. FOOD REVIEWS INTERNATIONAL, 2007, 23 (04) : 407 - 433
  • [19] Correlation between structure and corrosion behaviour of nickel dispersion coatings containing ceramic particles of different sizes
    Lampke, Th.
    Leopold, A.
    Dietrich, D.
    Alisch, G.
    Wielage, B.
    [J]. SURFACE & COATINGS TECHNOLOGY, 2006, 201 (06) : 3510 - 3517
  • [20] The study of corrosion stability of organic epoxy protective coatings on aluminium and modified aluminium surfaces
    Lazarevic, ZZ
    Miskovic-Stankovic, VB
    Kacarevic-Popovic, Z
    Drazic, DM
    [J]. JOURNAL OF THE BRAZILIAN CHEMICAL SOCIETY, 2005, 16 (01) : 98 - 102