Effect of nanosilica-based activators on the performance of an alkali-activated fly ash binder

被引:147
|
作者
Rodriguez, Erich D. [1 ]
Bernal, Susan A. [2 ]
Provis, John L. [2 ]
Paya, Jordi [1 ]
Monzo, Jose M. [1 ]
Victoria Borrachero, Maria [1 ]
机构
[1] Univ Politecn Valencia, Inst Ciencia & Tecnol Hormigon, Valencia 46022, Spain
[2] Univ Melbourne, Dept Chem & Biomol Engn, Melbourne, Vic 3010, Australia
来源
CEMENT & CONCRETE COMPOSITES | 2013年 / 35卷 / 01期
基金
澳大利亚研究理事会;
关键词
Alkali-activated binders; Soluble silicate solutions; Nanosilica; X-ray diffraction; Scanning electron microscopy; METAKAOLIN GEOPOLYMERS; COMPRESSIVE STRENGTH; SOLUTION CHEMISTRY; THERMAL EVOLUTION; SODIUM-SILICATE; X-RAY; ZEOLITES; SEM; MICROSTRUCTURE; DISTRIBUTIONS;
D O I
10.1016/j.cemconcomp.2012.08.025
中图分类号
TU [建筑科学];
学科分类号
0813 ;
摘要
This paper assesses the effect of the use of an alternative activator based on nanosilica/MOH (M = K+ or Na+) blended solutions on the performance of alkali-activated fly ash binders. Binders produced with commercial silicate activators display a greater degree of reaction, associated with increased contents of geopolymer gel; however, mortars produced with the alternative nanosilica-based activators exhibited lower water demand and reduced permeability, independent of the alkali cation used. Na-based activators promote higher compressive strength compared with K-based activators, along with a refined pore structure, although K-activated samples exhibit reduced water demand. Zeolite type products are the major crystalline phases formed within these binders. A wider range of zeolites is formed when using commercial silicate solutions compared with the alternative activators. These results suggest that there are variations in the availability of Si in the system, and consequently in the alkalinity, depending on the silicate source in the activator, which is important in determining the nanostructure of the geopolymer gel. (C) 2012 Elsevier Ltd. All rights reserved.
引用
收藏
页码:1 / 11
页数:11
相关论文
共 50 条
  • [1] Alkali-activated Binder Based on Coal Fly Ash
    Stevulova, Nadezda
    Junak, Jozef
    CHEMICKE LISTY, 2014, 108 (06): : 620 - 623
  • [2] Shrinkage Performance of Fly Ash Alkali-activated Cement Based Binder Mortars
    Kheradmand, M.
    Abdollahnejad, Z.
    Pacheco-Torgal, F.
    KSCE JOURNAL OF CIVIL ENGINEERING, 2018, 22 (05) : 1854 - 1864
  • [3] Shrinkage Performance of Fly Ash Alkali-activated Cement Based Binder Mortars
    M. Kheradmand
    Z. Abdollahnejad
    F. Pacheco-Torgal
    KSCE Journal of Civil Engineering, 2018, 22 : 1854 - 1864
  • [4] PROPERTIES OF ALKALI-ACTIVATED FLY ASH MORTARS MADE WITH MULTIPLE ACTIVATORS
    Ghafoori, Nader
    Sierra, Kimberly
    Najimi, Meysam
    Sharbaf, Mohammadreza
    II INTERNATIONAL CONFERENCE ON CONCRETE SUSTAINABILITY - ICCS16, 2016, : 1332 - 1342
  • [5] Effect of Ultra-fine Fly Ash and Superplasticizer on Properties of Alkali-Activated Fly Ash Binder at Room Temperature
    Zhu H.
    Zhang Y.
    Li H.
    Jianzhu Cailiao Xuebao/Journal of Building Materials, 2023, 26 (04): : 419 - 428
  • [6] Microstructure Evaluation of Fly Ash Geopolymers Alkali-Activated by Binary Composite Activators
    Zhao, Jiangping
    Wang, Yachao
    MINERALS, 2023, 13 (07)
  • [7] Effect of Fly Ash Properties on Strength Development of Microwave-Heated Alkali-Activated Binder
    Zhu H.
    Yu C.
    Zhang X.
    Qiao P.
    Li H.
    Jianzhu Cailiao Xuebao/Journal of Building Materials, 2023, 26 (05): : 449 - 456
  • [8] Nanoindentation of Alkali-Activated Fly Ash
    Nemecek, Jiri
    Smilauer, Vit
    Kopecky, Lubomir
    Nemeckova, Jitka
    TRANSPORTATION RESEARCH RECORD, 2010, (2141) : 36 - 40
  • [9] Properties of alkali-activated fly ash: high performance to lightweight
    Brooks, Robert
    Bahadory, Mozhgan
    Tovia, Fernando
    Rostami, Hossein
    INTERNATIONAL JOURNAL OF SUSTAINABLE ENGINEERING, 2010, 3 (03) : 211 - 218
  • [10] Effect of Alkali-activators on the Strength Development and Drying Shrinkage of Alkali-activated Binder
    Chi, Mao-chieh
    Chang, Jiang-jhy
    Huang, Ran
    Weng, Zai-long
    ADVANCED COMPOSITE MATERIALS, PTS 1-3, 2012, 482-484 : 1012 - +