Precise Measurement of Photoresist Cross-sectional Shape Change Caused by SEM-induced Shrinkage

The mechanism of photoresist shrinkage induced by electron-beam (EB) irradiation was studied. A precise cross-sectional profile of a photoresist pattern was obtained by a scanning transmission electron microscope (STEM) after atomic layer deposition of HfO2 on the sample patterns. Photoresist lines and spaces fabricated with positive-tone development and negative-tone development were exposed to an EB with much higher dose than a practical dose (to accelerate shrinkage intentionally). The obtained STEM images of the patterns before and after EB irradiation show that the shrinkage of the negative-tone-developed patterns is smaller than that of the positive-tone-developed patterns. This observation is explained by the fact that negative-tone-developed photoresist molecules do not contain protection groups, whose volatilization caused by EB irradiation is one of the origins of shrinkage. Another finding is that the EB irradiation causes top-rounding and necking of the pattern profile as well as linewidth slimming. The rounding of the pattern top profile suggests that the pattern's shape was elastically deformed. In addition, EB irradiation only onto the spaces caused sidewall shrinkage and a necking profile, although no electrons were irradiated directly onto the pattern. These phenomena are considered to be due to the electrons scattered from the spaces to the pattern sidewall. Finally, a Monte Carlo simulation of electron scattering showed that the distribution of the deposited EB energy on the pattern surface corresponds to the above-described change in pattern shape. Consequently, these observations and simulation results clarify the importance of the effect of elastic shape change and the impact of the electrons scattered from the underlying layer onto the sidewall in the mechanism of photoresist shrinkage.