Charge distribution on the surface of a dielectric barrier discharge actuator for the fluid-dynamic control

The electric potential distribution induced on the surface of an aerodynamic plasma actuator, operating by means of a surface dielectric barrier discharge (DBD), has been studied both numerically and experimentally. Three actuators made with three different dielectric materials (Teflon, Plexiglas, and glass) have been used. The geometric configuration of the three actuators is the same one. An electrode pair separated by a 2mm thick dielectric sheet constitutes the DBD actuator. The exposed high voltage electrode has been fed by a 5 kHz a.c. electrical signal. Voltage values between 7.5 and 15 kVp have been used. Measurements of the distribution of the electrical potential in the dielectric surface, generated by the charge deposited on it, have been done. Numerical simulations allowed to evaluating the charge distribution on the dielectric surface. The discharge has been switched off after positive and negative plasma currents. The measurements have been carried out after both phases. The potential distribution is always positive. The charge build up takes place several centimeters downstream of the upper electrode for an extension broader than that of the plasma on the dielectric surface. The charge distribution strongly depends on the switching off phase and is heavily affected by the dielectric material. In order to evaluate the discharge structure and the extension of the plasma, images have been taken also. (C) 2013 American Institute of Physics. [http://dx.doi.org/10.1063/1.4799159]