Short-fibre-reinforced injection moulded parts

被引：0
|
作者：
Mlekusch, B [1 ]
机构：
[1] Montanuniv Leoben Osterreich, Zentrum Angew Technol, Bereich FEM Simulat & Verstarkte Thermoplaste Tat, Leoben, Austria
来源：
KUNSTSTOFFE-PLAST EUROPE | 1999年 / 89卷 / 07期
关键词：
D O I：
暂无
中图分类号：
TQ [化学工业];
学科分类号：
0817 ;
摘要：
引用
收藏
页码：33 / +
页数：3
相关论文
共 50 条
  • [1] Residual Stresses in Short-Fibre Reinforced Injection-Moulded Thermoplastic Parts
    Mlekusch B.A.
    Mechanics of Time-Dependent Materials, 1998, 2 (2) : 129 - 169
  • [2] The warpage of corners in the injection moulding of short-fibre-reinforced thermoplastics
    Inst. for Designing Plastics, University of Leoben, Leoben, Austria
    Compos. Sci. Technol., 12 (1923-1931):
  • [3] The warpage of corners in the injection moulding of short-fibre-reinforced thermoplastics
    Mlekusch, B
    COMPOSITES SCIENCE AND TECHNOLOGY, 1999, 59 (12) : 1923 - 1931
  • [4] SHORT-FIBRE-REINFORCED MATERIALS.
    Veldkamp, J.D.B.
    Philips Research Reports, Supplements, 1975, (04):
  • [5] Short-fibre-reinforced thermoplastic for semi structural parts: process-properties
    Haramburu, E
    Collombet, F
    Ferret, B
    Vignes, JS
    Devos, P
    Levaillant, C
    Schmidt, F
    REPAIRING STRUCTURES USING COMPOSITE WRAPS, 2003, : 293 - 304
  • [6] Measurements of fibre orientation in short-fibre-reinforced thermoplastics
    O'Connell, P.A., 1600, (42):
  • [7] Thermoelastic properties of short-fibre-reinforced thermoplastics
    Mlekusch, B
    COMPOSITES SCIENCE AND TECHNOLOGY, 1999, 59 (06) : 911 - 923
  • [8] Mechanical design of injection moulded parts made of short-fibre reinforced thermoplastics by means of integrative simulation
    Schmachtenberg, E
    Brandt, M
    JOURNAL OF POLYMER ENGINEERING, 2006, 26 (2-4) : 179 - 195
  • [9] Compressive behaviour of short-fibre-reinforced concrete
    Ghosh, S.
    Bhattacharjya, S.
    Chakraborty, S.
    MAGAZINE OF CONCRETE RESEARCH, 2007, 59 (08) : 567 - 574
  • [10] Voids in short fibre-reinforced injection-moulded parts: density control vs. mass control
    Saint-Martin, G
    Schmidt, F
    Devos, P
    Levaillant, C
    POLYMER TESTING, 2003, 22 (08) : 947 - 953
12345