Combustion synthesis/quasi-isostatic pressing of TiC0.7-NiTi cermets:: microstructure and transformation characteristics

TiC(0.7)-NiTi cermets were produced by combustion synthesis followed by quasi-isostatic consolidation while the reaction products were still hot and ductile. The TiC(0.7)-NiTi cermets were characterized by differential scanning calorimetry, room temperature transmission electron microscopy (TEM), and in-situ TEM (temperature varied during observation). The matrix of the as-synthesized 20NiTi, 40NiTi, and 60NiTi composites contains both R and B19' martensites at room temperature. No distinct R-phase morphology could be imaged. In the B19' martensite, [011] Type II twinning, (111) Type I twinning and (001) compound twinning modes were observed as the lattice invariant shear (LIS) of the R-B19' transformation. The [011] Type II twinning is often reported as the LIS of the B2- B19' transformation, but this is the first experimental confirmation of its predicted presence as a qualified LIS of the R-B19' transformation. The (001) compound twinning mode is responsible for the fine structure of the martensite with a wavy morphology. Nanoscale structures with a thickness of 5 nm were obtained inside the twins. Twinning was also observed at the interface with carbide particles, which confirms that some stress relaxation of the elastic mismatch occurs. At room temperature, the matrix of the 80NiTi composite had the R-phase structure, which appeared with a needle-like morphology. Thermal cycling resulted in the suppression of the R-phase transformation. This is the opposite of the behavior observed in un-reinforced NiTi alloys.