Comparison of Different Evaluation Methods to Determine Stray Load Losses in Induction Machines With Eh-Star Method

The eh-star method is a simple and economical alternative test for stray-load-loss assessment in induction machines, also for higher efficiency above 96%. It is an asymmetrical circuit where two machine phases are connected in parallel through an auxiliary ohmic resistance R(eh) without coupling of the machine and without needing any dynamometer. This resistance shall be adjusted, so that the positive sequence current I(1) stays below 30% of negative sequence current I(2). If this pure "ohmic" resistance is not available, the eh-star measurement can be done with an impedance (Z) under bar (eh), preferably ohmic inductive. The determination of stray load losses must be done from the measured losses by decomposition into positive and negative sequence losses. Negative sequence losses at slip 2 - s approximate to 2 correspond to stray load losses similar to the standardized reverse-rotation test (RRT). For this evaluation, the phase angles of measured currents and voltages must be known. This can he done by calculation with three different methods A, B, and C, which yield identical results for ideal ohmic resistance R(eh). Method A is only useful for an ohmic resistance R,h for determination of loss separation. Method B is based on the measured two line-to-line motor-input-power values P(e),in_UV and P(e),_WV. Instead of R(eh), also an impedance (Z) under bar (eh) (inductor, capacitor, or resistor) may be used. Method C is similar to method B, but only the measured total motor input power P,in is needed. A comparison of evaluated stray load losses with the three evaluation methods is given with theoretical examples and measurements. This is compared to stray load losses and measured with RRT and input-output method according to IEEE-112.