Investigation of a two impinging-jets contacting device for liquid-liquid extraction processes

被引:47
|
作者
Saien, Javad [1 ]
Zonouzian, S. Alireza Ebrahimzadeh
Dehkordi, Asghar Molaei
机构
[1] Sharif Univ Technol, Dept Chem & Petr Engn, Tehran, Iran
[2] Bu Ali Sina Univ, Dept Appl Chem, Hamedena 65174, Iran
关键词
impinging jets; impinging streams; liquid extraction; mass transfer; liquid-liquid separations; transport processes;
D O I
10.1016/j.ces.2006.01.034
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
A two impinging-jets contacting device (TIJCD) for liquid-liquid extraction processes was proposed and tested through the standard test system recommended by the European Federation of Chemical Engineering (EFCE), toluene-acetone-water, as a typical example of liquid-liquid extraction processes. The results obtained for the overall volumetric mass transfer coefficient (capacity coefficient) were more than three times higher than those reported in the conventional contactors and in an air-driven two impinging-streams contactor. These experimental results clearly indicate the greater performance capability of TIJCD relative to those of conventional contactors. To have a perfect study on the pertinent parameters of the TlJCD, the influence of jets momentum, nozzles diameter and the inter nozzle distance have been investigated. In addition, the enhancing effect of the impingement zone has been studied using a non-impinging-jets contacting device. Based on the experimental data obtained, an increase in the liquid flow rates results in an increase in the extraction efficiency and overall volumetric mass-transfer coefficient, while increasing the distance between nozzles decreases the extraction efficiency. In addition, it was found that the effect of nozzle diameter on the extraction efficiency could be dependent upon the jets velocity. (c) 2006 Elsevier Ltd. All rights reserved.
引用
收藏
页码:3942 / 3950
页数:9
相关论文
共 50 条
  • [21] Use of Liquid-Liquid Extraction Processes in Hydrometallurgy.
    Ziegenbalg, Siegfried
    Neue Huette, 1975, 20 (03): : 181 - 189
  • [22] Separation and purification of lipases by liquid-liquid extraction processes
    CarneiroDaCunha, MG
    Melo, EP
    Sebastiao, MJ
    AiresBarros, MR
    Cabral, JMS
    ENGINEERING OF/WITH LIPASES, 1996, 317 : 551 - 576
  • [23] Application of an Air-operated impinging streams contactor in liquid-liquid extraction
    Dehkordi, Asghar Molaei
    Kaghazchi, Tahereh
    Sohrabi, Morteza
    Chemical Engineering and Technology, 2001, 24 (02): : 173 - 179
  • [24] Application of an air-operated impinging streams contactor in liquid-liquid extraction
    Dehkordi, AM
    Kaghazchi, T
    Sohrabi, M
    CHEMICAL ENGINEERING & TECHNOLOGY, 2001, 24 (02) : 173 - 179
  • [25] A STUDY OF IMPINGING LIQUID JETS IN A LIQUID STREAM
    KRETSCHMAR, GG
    WEDAA, HW
    PHYSICAL REVIEW, 1952, 88 (01): : 161 - 161
  • [26] LIQUID-LIQUID CONTACTING IN UNBAFFLED, AGITATED VESSELS
    WEINSTEIN, B
    TREYBAL, RE
    AICHE JOURNAL, 1973, 19 (02) : 304 - 312
  • [27] Evaluation of heat transfer in quenching processes with impinging liquid jets
    Waldeck, Steffen
    Woche, Hermann
    Specht, Eckehard
    Fritsching, Udo
    INTERNATIONAL JOURNAL OF THERMAL SCIENCES, 2018, 134 : 160 - 167
  • [28] Hydrodynamics of bioreactor systems for liquid-liquid contacting
    Tsouris, C
    Lizama, HM
    Spurrier, MA
    Takeuchi, TL
    Scott, TC
    APPLIED BIOCHEMISTRY AND BIOTECHNOLOGY, 1996, 57-8 : 581 - 592
  • [30] An inkjet-printed microfluidic device for liquid-liquid extraction
    Watanabe, Masashi
    ANALYST, 2011, 136 (07) : 1420 - 1424