Molecular dynamics study of strain rate effects on tensile behavior of single crystal titanium nanowire

被引:57
作者
Chang, Le [1 ]
Zhou, Chang-Yu [1 ]
Wen, Lei-Lei [1 ]
Li, Jian [1 ]
He, Xiao-Hua [1 ]
机构
[1] Nanjing Tech Univ, Sch Mech & Power Engn, Nanjing 211816, Jiangsu, Peoples R China
基金
中国国家自然科学基金;
关键词
Molecular dynamics; Single crystal titanium nanowire; Strain rate; Tensile properties; Plastic deformation mechanisms; COMMERCIALLY PURE TITANIUM; DEFORMATION MECHANISM; ALPHA-TITANIUM; PHASE-TRANSFORMATION; TWINNING BEHAVIOR; PURITY TITANIUM; YIELD STRENGTH; GRAIN-SIZE; SIMULATION; MAGNESIUM;
D O I
10.1016/j.commatsci.2016.11.034
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Molecular dynamics simulations were performed to study the tensile behaviors of single crystal titanium nanowire along [ 0001] direction under different strain rates using the Finnis-Sinclair many-body potential. The applied strain rate is ranging from 108 s(-1) to 1011 s(-1) (0.0001-0.1 ps(-1)). At strain rates below 0.01 ps(-1), the stress-strain curves can be divided into four distinct stages: initial linear stage, sharp drop stage, rapid rise stage and wavelike decrease stage. Structural analysis reveals that the growth of f10 (1) over bar 2g tensile twin leads to the rapid rise stage in stress-strain curves. The evolution of twinning variants indicates that the number of nucleated twin variants increases with the applied strain rate and the overall twin volume fraction decreases with strain rate. At strain rates above 0.01 ps(-1), three distinct stages are observed in the stress-strain curves. At these strain rates, a rapid transformation to an amorphous state was observed leading to superplastic behavior of nanowire. Besides, deformation mechanism map was constructed for nanowire during tension process at different strain rates. (C) 2016 Elsevier B. V. All rights reserved.
引用
收藏
页码:348 / 358
页数:11
相关论文
共 51 条
[1]   THEORETICAL-STUDY OF TITANIUM SURFACES AND DEFECTS WITH A NEW MANY-BODY POTENTIAL [J].
ACKLAND, GJ .
PHILOSOPHICAL MAGAZINE A-PHYSICS OF CONDENSED MATTER STRUCTURE DEFECTS AND MECHANICAL PROPERTIES, 1992, 66 (06) :917-932
[2]   Micromechanical modeling of hardening mechanisms in commercially pure α-titanium in tensile condition [J].
Amouzou, K. E. K. ;
Richeton, T. ;
Roth, A. ;
Lebyodkin, M. A. ;
Lebedkina, T. A. .
INTERNATIONAL JOURNAL OF PLASTICITY, 2016, 80 :222-240
[3]   A Study of Twin Variant Selection and Twin Growth in Titanium [J].
Bao, Lei ;
Schuman, Christophe ;
Lecomte, Jean-Sebastien ;
Philippe, Marie-Jeanne ;
Zhao, Xiang ;
Esling, Claude .
ADVANCED ENGINEERING MATERIALS, 2011, 13 (10) :928-932
[4]   Characterization and analysis of deformation heterogeneities in commercial purity titanium [J].
Barkia, B. ;
Doquet, V. ;
Heripre, E. ;
Guillot, I. .
MATERIALS CHARACTERIZATION, 2015, 108 :94-101
[5]   Work-hardening stages and deformation mechanism maps during tensile deformation of commercially pure titanium [J].
Becker, Hanka ;
Pantleon, Wolfgang .
COMPUTATIONAL MATERIALS SCIENCE, 2013, 76 :52-59
[6]   {10-12} Twin variants selection mechanisms during twinning, re-twinning and detwinning [J].
Chapuis, Adrien ;
Xin, Yunchang ;
Zhou, Xiaojun ;
Liu, Qing .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 612 :431-439
[7]   Analysis of twinning behavior of pure Ti compressed at different strain rates by Schmid factor [J].
Deng, X. G. ;
Hui, S. X. ;
Ye, W. J. ;
Song, X. Y. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2013, 575 :15-20
[8]   Strain rate and orientation dependencies of the strength of single crystalline copper under compression [J].
Dupont, Virginie ;
Germann, Timothy C. .
PHYSICAL REVIEW B, 2012, 86 (13)
[9]   Why are {10(1)over-bar2} twins profuse in magnesium? [J].
El Kadiri, Haitham ;
Barrett, Christopher D. ;
Wang, Jian ;
Tome, Carlos N. .
ACTA MATERIALIA, 2015, 85 :354-361
[10]   Effects of grain size and temperature on mechanical response of nanocrystalline copper [J].
Fang, Te-Hua ;
Huang, Chao-Chun ;
Chiang, Tsung-Cheng .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2016, 671 :1-6