The mechanical properties of rolled wire-reinforced aluminum composites at different strain values

被引：3

作者：

Stolbchenko, Mykhailo ^{[1
]}

Frolov, Yaroslav ^{[1
,2
]}

Makeieva, Hanna ^{[2
]}

Grydin, Olexandr ^{[1
]}

Tershakovec, Michael A. ^{[3
]}

Schaper, Mirko ^{[1
]}

机构：

[1] Paderborn Univ, Dept Mat Sci, Paderborn, Germany

[2] Natl Met Acad Ukraine, Dept Met Forming, Gagarin Av 4, UA-49600 Dnipro, Ukraine

[3] Johns Hopkins Univ, Dept Mat Sci & Engn, Baltimore, MD 21218 USA

来源：

MECHANICS OF ADVANCED MATERIALS AND STRUCTURES | 2020年 / 27卷 / 18期

关键词：

Aluminum matrix; rolling; reinforcing; steel net; delamination; strain; mechanical properties; WARM;

D O I：

10.1080/15376494.2018.1520941

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The analysis of strain parameters at rolling of aluminum composite with wire-reinforcement was carried out in the present experimental work. The roll bonding of two strips of EN AW-5083 alloy with and without diagonal stainless-steel net-reinforcement between them was experimentally proceeded with different reductions. It is analyzed the influence of the rolling reduction in the range from 25% to 55% on the straining of the wires and composite bonding mechanisms. The present experimental work is established and used the set of describing parameters of the net behavior in the composite such as net cell elongation, wire elongation and wire ovalisation. The means of longitudinal and transversal tensile testing, impact testing and microscopic analysis determine the properties of the rolled composite. The analysis of the rolling reduction influence on the mechanisms of bonding formation in the composite its properties and fracture behavior are carried out. Based on the conducted tests, it was established the optimum range of rolling reductions.

引用

页码：1599 / 1608

页数：10

共 23 条

[21] Manufacturing Al/steel multilayered composite by accumulative roll bonding and the effects of subsequent annealing on the microstructural and mechanical characteristics [J].

Talebian, Milad ;

Alizadeh, Mostafa .

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 590 :186-193

[22]

Tekkaya AE, 2012, P 45 ICFG PLEN M ICF, P57

[23] A deformation mechanism of hard metal surrounded by soft metal during roll forming [J].

Yu, Hailiang ;

Tieu, A. Kiet ;

Lu, Cheng ;

Liu, Xiong ;

Godbole, Ajit ;

Li, Huijun ;

Kong, Charlie ;

Qin, Qinghua .

SCIENTIFIC REPORTS, 2014, 4

← 1 2 3 →